If you have a canine family member give them a special hug and kiss today

On Valentine’s Day my best baby boy Merlin passes in our arms in our bed. Exhausted from a year long battle with heart failure.

They have no voice but they are our forever wingman.
Merlin went everywhere and was the most kindest and non malevolent souls I have ever met.

I hurt so deeply inside.
No joy in my toys for now

The wood stocked version of the 362 is looking NICE!! . Check out the HAM article!
Can’t wait to get my mitts on one of these. Wish they were putting threaded barrels on them though.
(Tried posting a picture but it won’t let me upload anything right now for some reason.)

Been sorting pellets this week:
After shooting last Summer with the RAW at 50 & 100 yards, head size didn't seem to matter (within reason) as much as pellet weight.
When I sort my JSB 18.1, 25.39's or 33.95's, most pellets in tim are just two head sizes (.01 apart). Now just sorting by weight.

Shot some (.25 cal) 33.95 and noticed a 1.3 grain difference lead to a 25 fps difference over the crony. Trying to determine realistic weight ranges for different pellets to keep ES around 10 fps. Right now sorting by .10 differences, but hope to go to .20 or higher for simplicity - if can reasonably expect a 10 fps ES.

I know, the lighter the pellet, the tighter the range will need to be because of the different masses.

All this assumes my regulator is constant - which is not realistic, but ......

Demo 6-24x50 Arken . Level throw lever caps eagle vision ins rings 350 shipped

Up for sale is a Taipan Long in 25 with a power plenum and FX Superior liner and Huma Regulator.

This rifle has the MtnGhost Taipan to FX barrel system which has an FX Superior liner with a carbon fiber sleeve on it and the liner has been indexed.

Also included in the price is a MtnGhost transfer port and poppet if you really want to push the power. (Not installed)

Currently the rifle is tuned to shoot the 34 grain pellets right at 920 FPS.

Included in the sale is everything above plus 3 magazines, a fill probe, a DonnyFL hammer spring adjuster, extra O'rings, a single shot tray, the magazine holders, biathlon cocking lever, and 3 different weight hammer springs.
Below was a group I shot with it last weekend at 50 yards before I put it in the safe. Want to pick up an Alkin compressor , so this and a couple other rifles are up for grabs.

$1200 shipped without the bipod ,moderator, or scope.



Paypal F&F or pay the fees.

No trades

This is pretty much new my gun didn't like it and I only have 1 22cal .. I'm asking $150 shipped PayPal f&f

Check it out at AIRGUN101.COM.

Anyone with a Brocock Sniper XR chime in? I'm looking at the .22 calibur will it shoot pelets and slugs with out having to swap things out? Is it easy to tune? How's the quality compared to a FX? Have you had any issues with it? How accurate is it out to 100yd? What's the diffrence between this and the Magnum? Is the Magnum woth the extra cost?


Just looking to plink, field and target shoot from 25-100yds. Looking for accuracy, adjustibiltiy and durability I guess would be my top 3 primary options.

How do you attract them? I’ve got a lot of pigeons and doves around my area. I’m positioned about 6 yards away from them and I’m shooting from inside the house. I’ve got an outdoor balcony, but I’m not familiar with the best ways to attract them. Let me know and thanks.

Using only 6 foot pounds of energy so no pass through as I don’t want to risk a ricochet.

My battles with tuning guns for slug use have been as many others- trial and error. Until I met Steve from AVS . He educated me about variables involving slug success. Obviously proper tune, but , tune is length, weight, speed and twist rate of barrel dependent. Extensive testing and adjustments to garner the right projectile at the correct weight and speed for that barrel twist rate. But once there, you are golden.

Tired of adjusting things for distance? Me too...
Left side: Canted iron sights(0-20yards
Middle: Scope(40+yards
Right side: Canted mount for red dot(20-40yards)

I am ITCHING to try this out

I was brought up on modern black rifle style platforms. I really want a classic hunting style repeater, possibly with wood stock. Only thing is I’m a smaller guy at 5’6 and have a strong preference for carbines and compacts due to the size and location of my yard

Can’t seem to find anything shorter than 35” and even then id have to add a few inches for moderator.

Any suggestions? I really like the look of the raw 1000 and the crown…

Happening now, kind of a proof of concept fill/run for my yong heng. Cobbled together a setup with radiator water cooling and some electric fans.

I picked up 2 60 minute scba tanks off ebay. Seller emptied them before shipping. How long will it take, gonna see if I can find a stable temp for the compressor and just ket it run.

In gonna be plinking, target shooting an. Shooting field targets ranging from 20-125yds.
Anyone make a recommendation for a decent scope to be used with a pcp air rifle

Whats a decent scope at a decent budget?

Very new to this scene and dont know what the terminology is.

Theoben Rapid MKII Air Rifle .25 cal. Fully shrouded, 500cc air tank, fill pressure 3500 lbs, thumb hole walnut stock, very accurate, 12 round rotary clip, beautiful rifle!!!! Asking $2095.00 plus S&H.
Selling for my father in law. May take time to respond as I will have to go through him.

Found out this today
This one wanted to goutside so bad that it stood up
Too cold buddy, sorry.

So I broke them all out and commenced maintenance on them all

Not sure what they are, are these 2 Talons and a Condor from Left to Right?

Serial Numbers on the left 2 are BS02xxx & BS01xxx
Serial Number on the right 1 is BC01xxx

Also 1 of them was tuned by Tony @ Talon Tunes, any way I can figure out which one that is?

The hammer on the 2 on the left that I think are Talons are a bronze/gold color, the hammer weight on the one I think is a Condor is graphite/black.

Thanks for any help ya'll.

Sold....

All painted up and time to make em ring out to 70 yds.

i think mayor adans needs to hire a few guys with air rifles to fix his rat problem.

I have this box target (chunk rubber mulch), well now it has approximately 4000 rounds of .22 cal. pellets and is getting extremely heavy, you can see the box bulging. What do I do with it? I don't want to just dump all that lead out in the yard, I put enough out there already from my spinner targets. I don't want to build some fancy contraption just to sift out the pellets. What does everyone else do?

Saw this at the 2022 RMAC and I’d like to look more into it to see if it is height adjustable, swivel seat, etc.

Does anyone know who manufactures or sells this particular seat? Hopefully the shooter who owns it is a member here on AGN

A new version of the Altaros silencer combines the technology of a classic airgun silencer and the technology of a muzzle brake / compensator. By combining both elements into one unit, a unique device is created that even better reduces the noise during the shot and at the same time diverts the expanding residual air away from the path of the bullet, which leads to increasing the precision of shooting.

https://www.altaros.cz/accessories/210-silencer-with-muzzle-brake-22.html .22 caliber
https://www.altaros.cz/accessories/209-silencer-with-muzzle-brake-25.html .25 caliber







This new type of suppressor was used in this shooting video:

ok,i have a dilemma i had not accounted for.

ive always ran scope tube mounted levels to be able to adjust the level to the crosshairs after aligning the crosshairs with the bore.

im putting a new compact scope on my notos,
but there will be no room left on the tube for a level as the rings take up all but a few millimeters of availabe scope tube real estate.

does anyone make an adjustable level that will mount somewhere else?

i have an old rail mounted level,
but its not adjustable.

i thought about trying to find a magnification throw lever that would fit the ocular housing and mount a level on that,
but figured id ask first lol

I am offering my FX Maverick VP in .25. The Maverick is tuned right now for JSB 25.39 King Diabolo pellets.
Current Build:
FX Maverick VP .25 caliber $1499
Saber Tactical butt stock $250
Saber Tactical Under Bottle Arca Rail with short Picatinny rail $150
Donny FL Sumo Moderator $150
Carbon Fiber Barrel Liner Sleeve $30
Element Helix 6-24x50 SFP scope $499
Eagle Vision Rings $100
5 magazines $245
Pelican 730 vault $225
$3150 initial investment when bought new in 2021.

I would like to sell this as a complete package, ready to shoot out of the box.
Asking $2100 for the entire package plus Shipping & Insurance by buyer. Local pickup is possible in SE Wisconsin.
Best way to contact me is to text or call 414 -469- one six two six, or email [email protected]