TUXING 4500PSI PCP Air Compressor Review

gasket on plate if just a tiny bit nicked, you get small amount of water in line going to hi pressure side, and it will stop pump. After a tiny bit of water gets out, it will pump again, until it builds up again. The amount of water needed to stop the pump is tiny. If check seal gets stuck, it too can stop pump. I’d start by taking off low compression side, and check for signs of water on plate were low pressure reed plate is. If water gets in low compression side, it will transfer to hi compression side. If it’s a really small amount most of it gets caught on cotton filter. If the water sneaking in is too much, it will stop the pump. Ask me how I know lol
 
  • Like
Reactions: Normkel
gasket on plate if just a tiny bit nicked, you get small amount of water in line going to hi pressure side, and it will stop pump. After a tiny bit of water gets out, it will pump again, until it builds up again. The amount of water needed to stop the pump is tiny. If check seal gets stuck, it too can stop pump. I’d start by taking off low compression side, and check for signs of water on plate were low pressure reed plate is. If water gets in low compression side, it will transfer to hi compression side. If it’s a really small amount most of it gets caught on cotton filter. If the water sneaking in is too much, it will stop the pump. Ask me how I know lol
If water is leaking pressure will go to water tank and blow its lid off. Been there dine that. Leaving cooling running while compressor stop allowed cylinder to fill with water and hydrolock. So had both experiences, fun stuff.
 
I find them to be fairly quiet considering how fast they are. Mine will put 1100 psi in a 45 minute SCBA in 11 minutes. Can your GX do that? But yes, they are too loud to use in your house.
Well, my GX put 70 bar into my 9L tank in 16 minutes. (That's 3,400 to 4,500 psi) So pretty close. And I was able to watch TV while doing it. :cool:
 
The only thing they respond to in a situation like this is pesistent work on your part. 2-3 hours claims through aliexpress, bad reviews, chargeback on credit card. Do all 3. Unless you want to be the repair center. Repairing is an option if you are technical and want to invest the time. If you rebuild it with proper assembly maybe even without parts, it will work.
Thank you!
 
Thank you!
Aliexpress unlike Alibaba has a Customer return policy similar but suckier than ebay/amazon. You have to "accept the package" or mark as delivered. Then you can file a claim through their system. You'll go back and forth, demands for pictures, videos, explanations, etc. Eventually Aliexpress steps in and assists. Just takes hours over days of time due to the time difference. I'm in Los Angeles they typically get to work and start responding around 5-7pm my time.
 
  • Like
Reactions: Normkel
Aliexpress unlike Alibaba has a Customer return policy similar but suckier than ebay/amazon. You have to "accept the package" or mark as delivered. Then you can file a claim through their system. You'll go back and forth, demands for pictures, videos, explanations, etc. Eventually Aliexpress steps in and assists. Just takes hours over days of time due to the time difference. I'm in Los Angeles they typically get to work and start responding around 5-7pm my time.
I've had a few claims to AliExpress which they have handled well, although the time can be long, as your experience. I have had at least (3) issues in which Amazon have credited me when they should not have, and madness lies in the path of trying to get them to understand that the item was delivered, despite that their system says not and times out. Trying to get them to reverse the credit/to charge me for the item is laborious but I'm either honest or I am not, so I perservere in paying for what I receievd.