Replacement hose/fittings for Yong Heng compressor

[OatmealMu]

I recently inspected the filters for my Yong Heng compressor. I immediately noticed rust forming where the hose connects to the first filter. I directly fill the gun and only have around 5 minutes on the compressor, so I figured I wouldn't have to inspect the filters yet, let alone be on the lookout for rust. Live and learn. Today, I ordered a replacement hose and molecular sieve filter from AliExpress. After more thinking, I also picked up a 24" hose from Amazon. The problem is that I need a way to connect the 24" hose directly to the compressor. From what I understand, the Yong Heng hose uses M10x1 threads. Given the rust issues, I'm looking for a quality fitting. I've found this and this so far.

Any suggestions?

Thanks.

 

[WorriedMan]

Oatmeal,
Used this adapter to connect my system using that same Amazon hose with the original Yong Heng fill whip affixed to compressor. WM

 

[OatmealMu]

Oatmeal,
Used this adapter to connect my system using that same Amazon hose with the original Yong Heng fill whip affixed to compressor. WM View attachment 334081

To clarify, I'm looking for an adapter I can screw directly into the compressor, although I might end up needing what you have, too. I was hoping to find a male quick disconnect fitting that has threads compatible with the Yong Heng.

 

[WorriedMan]

Oatmeal,
Yeah, figured that from your pictures, I've seen others with that set-up, just tricky to find the correct thread to tighten down all the way to seal against the white plastic "donut" washer. The 10mm thread on the YH hose end appears non-tapered, so would avoid tapered. I found it easier, and less expensive, to use adapter. WM

 

[wdr2]

I ordered this fitting: https://www.amazon.com/dp/B07J2G5VWH?psc=1&ref=ppx_yo2ov_dt_b_product_details

 

[rc4fun]

@wdr2 please let us know if it fits.
TKS

 

[scopecreep...]

The vibration from the compressor will eat Foster fittings. The hose is there for vibration dampening with a Foster connector properly isolated on the end.

 

[wdr2]

The vibration from the compressor will eat Foster fittings. The hose is there for vibration dampening with a Foster connector properly isolated on the end.

I suspect that is exactly the case. Thanks for sharing

 

[DesertSilver]

I ordered this fitting: https://www.amazon.com/dp/B07J2G5VWH?psc=1&ref=ppx_yo2ov_dt_b_product_details

I think this will cause problems beings it's a one way valve.