Does anyone know how this degasses? unscrew the tank? and also can the barrel be indexed? (loosened, spun 45 degrees in place, retightened).
Last edited:
Oh dang. My tank was loose when I got it...so I'm going to try and crank on that sucker now and see what happens....I loosened the tube pressure gauge.
Tank is hot swap, and can be removed full psi. The jam nut goes towards the tank to lock it in place. Good luck. Aea master slugs are my go to round for the tightest groupsDoes anyone know how this degasses? unscrew the tank? and also can the barrel be indexed? (loosened, spun 45 degrees in place, retightened).
View attachment 565952
Yea my regulator is inconsistent, which makes Fps inconsistent, which changes POI when shooting. Hopefully there's a fix in the future. My trigger is good after adjusting the linkage, and the sear screw. I can go hole in hole 2 or 3 times then miss by a half inch. It's frustrating.So far I’m not a fan of this gun. Trigger problems, regulation problems, accuracy? Hope to get to that after other problems…
Heavy, expensive compared to what can be got. I jumped on it too quick.
How many dealers say “ no returns “ in the first communication .
Mine was spot on. I showed the FPS for the whole video (posting tomorrow). I would say exchange it or have them send you a new reg under warranty.Yea my regulator is inconsistent, which makes Fps inconsistent, which changes POI when shooting. Hopefully there's a fix in the future. My trigger is good after adjusting the linkage, and the sear screw. I can go hole in hole 2 or 3 times then miss by a half inch. It's frustrating.
No returns? Heck no. Who is trying to pull that crap? I'll get that sorted out real fast. Just PM me.So far I’m not a fan of this gun. Trigger problems, regulation problems, accuracy? Hope to get to that after other problems…
Heavy, expensive compared to what can be got. I jumped on it too quick.
How many dealers say “ no returns “ in the first communication .
My hammer spring is at 0 clicks from 0. It's at 0, reg at 2150 psiAfter I saw your video, I pull out mine and start tinkering with it now I don’t know how many turns was in the hammer is it stops and then you can still go out like 11 clicks can you tell me how many clicks is your hammer in from absolute off. In mind, the power adjustment works different maximum. It’s maximum the middle cut down to about 770 from 820. What I’m using 20 grain slugs and minimum keeps me about 280 ft./s with the same slugs.
Thank you very much Nate keep up the good work man. You make some of the best videos and I love your sense of humor. Plus we’re almost neighbors. I’m over here in Puyallup.My hammer spring is at 0 clicks from 0. It's at 0, reg at 2150 psi