I have the hatsan piledriver rifle, and was noticing it was shooting with no pressure. After taking it apart the knocklever fell out and it's broken. I glued it back together and made a mold and cast a new stronger one but I have no idea where it goes or how to install it.Does anybody have any idea how to install it on the rifle? When I took the rifle apart it just fell out I didnt see where it was located.
Hatsan piledriver knocklever installation?
- Thread starter ibtheone
- Start date
It goes into the receiver and is held in by a pin. On my picture it goes into the end of the slot. There is also a diagram of it on hatsans website. Very easy to do. Where mine broke , I just welded it back together and ground it smooth. So far it’s working great. Good luck
Upvote 0
I have no idea who you are or the person who needed the help but as a member of this forum I was 99.9% sure you would reach out and assist this other member. That's just how AGN members are. Well good on you for helping make AGN awesome. Have a good day. Agnutty
Upvote 0
https://hatsanairgunsusa.com/wp-content/uploads/2020/12/Piledriver-Exploded-View.pdf
i found one and you can see how they have heat treated the end
https://sharg.pl/product-eng-120439...ement-and-knock-lever-PART-3330HP-5903HP.html
i found one and you can see how they have heat treated the end
https://sharg.pl/product-eng-120439...ement-and-knock-lever-PART-3330HP-5903HP.html
Last edited:
Upvote 0
I wanna thank you all for your help, this is a great forum. I will attempt to install it today.
Upvote 0
I always dump as much praise as I can about this forum. Some of the senior members are absolutely hands down the most knowledgeable and helpful people when it comes to guidance. They will ask you the questions that you don't know to ask yourself so that they can give you the most informed opinions. Any way welcome and always lean on the forum for your air gun problems. Have a good day. Agnutty
Upvote 0