I have the hatsan piledriver rifle, and was noticing it was shooting with no pressure. After taking it apart the knocklever fell out and it's broken. I glued it back together and made a mold and cast a new stronger one but I have no idea where it goes or how to install it.Does anybody have any idea how to install it on the rifle? When I took the rifle apart it just fell out I didnt see where it was located.
Hatsan piledriver knocklever installation?
- Thread starter ibtheone
- Start date
It goes into the receiver and is held in by a pin. On my picture it goes into the end of the slot. There is also a diagram of it on hatsans website. Very easy to do. Where mine broke , I just welded it back together and ground it smooth. So far it’s working great. Good luck
Upvote 0
I have no idea who you are or the person who needed the help but as a member of this forum I was 99.9% sure you would reach out and assist this other member. That's just how AGN members are. Well good on you for helping make AGN awesome. Have a good day. Agnutty
Upvote 0
https://hatsanairgunsusa.com/wp-content/uploads/2020/12/Piledriver-Exploded-View.pdf
i found one and you can see how they have heat treated the end
https://sharg.pl/product-eng-120439...ement-and-knock-lever-PART-3330HP-5903HP.html
i found one and you can see how they have heat treated the end
https://sharg.pl/product-eng-120439...ement-and-knock-lever-PART-3330HP-5903HP.html
Last edited:
Upvote 0