Recent content by Yorkie

Or get the Daystate transducer. Probably would screw straight into the plenum gauge hole.

I’m not sure about that. I had a DW and it has a regulator. I think the RW and AW are the same. I didn’t have the valve out my delta Wolf but from pics it looks about standard, say 8mm. A simple calculation shows it should be possible to get more energy from an electric system than most...

I recon my (normal) hammer when cocked has about 0.5 J energy. A 2000uf capacitor at 70v has 5J of energy. In theory there should be lots of spare energy even if the solenoid coil is quite inefficient. I cant find any info as to whether for a capacitor dump, more thin windings or less fat ones...

Hi guys, just found this thread. I have contacted the guy that makes these and waiting to hear back. I would like to try to get it fitted in a RTI Prophet. I know there are many challenges, like no LCD or switches on the gun for programming but Im sure its possible. Right now I would like to...

After a few months of struggling with the P2 with poor velocity spread and leaks I decided to have a go at fitting a standard type valve. The new valve is turned for PEEK with hardened 3mm steel rod. Other changes to make it work - Balance tube part drilled out to 6mm, O ring removed and 1mm...

That last gun is not the same as the P3 which looks like a slightly updated P2

Apparently seen at some show. Not yet on the RTI website. It seems they may have dropped the troublesome (P2) balanced valve and gone for a more conventional one.

I think this thing still needs some work. Check out the speeds.

I don’t see a problem trying the RPB barrel on a P1. Yes there are a high proportion of P2 owners reporting problems. If there are ones who are 100% happy they certainly don’t comment much.

This is the other half of the main valve. It helps a lot to polish it.

Didn't actually dissemble, inspect or polish the main valve which in inside the 'cup' part underneath plastic disk. It could be scratched like mine was.

Unfortunately I’ve been basing most of my speed spread comments on the FX radar. Recently there seems to have been a bit of a backlash and comments that these are producing inaccurate and wild results. When I measure with the Skan the speed spread is way better (10 compared with 40). The gun is...

If my internal block measurements are correct the valve will be long enough

Ill probably have a go at modifying the valve with a new brass one and balance tube. The top one is the 3rd RTI version of the valve.