Recent content by txrpls

1199.37

The regulator fits fine. The only problem I have now is I have to assemble the rifle to fill the bottle. I'm sure someone makes an adapter.

From here: https://www.bestfittings.co.uk/

Thanks to Motorhead's information, I now have it working. I have ordered a regulator tester and will get it back to specifications.

Any suggestion on where to get factory spec on the correct length?

Update: I ordered a repair kit and replaced all the O rings in the V block, and the air was still leaking. I isolated it to the hole shown by the red arrow. I next removed the part indicated by the orange arrow. It houses the regulator, and I replaced all those O rings as well. Now I am...

Thanks for the suggestions. I did dry fire with no luck. I ordered a reair kit today.

Long time no posting. My HM 1000 is leaking. After I fill it up, I still hear hissing. If I remove the bottle, I hear hissing until it empties. Any help in pointing me out what to check first would be appreciated.

The only problem I had with the LabRadar was getting the moderator too close to the Mic. After I figured that out, the unit has been great to use but as stated above, the phone app is rudimentary, much room for improvement.

I got tired of the inconsistent FPS based on placement and sent mine back. I'll stick with the LabRadar. 

Up for sale is my Combro Chronograph with the serial interface to connect to a computer. This unit is great for getting quick confirmation of gun adjustments without having to set up a big Chrono or one you have to shoot through. Just strap it on your barrel and line up with a drinking straw or...

I would like to sell two of the high-pressure Chinese filters. One has the unused original filter material, the other is empty. I used this with my Air Venturi Compressor for over a year. Also included is the remaining Zeolite molecular seive from my original purchase. $50 PayPal F&F plus...

The manual for the A/V manual specifies changing the output air filter every 50 hours. It comes with an extra replacement. According to everything I have read, the molecular seive is not effective unless you have a back pressure regulator on the seive to increase the dwell time of the air as it...

I changed the vibration meter to high sensitivity and found it to be unreliable. I wanted it installed on top of my compressor where I could read it. I left it installed and now have about a four-hour difference between meters.

Here is what I did. There are several threads on this on one of the other sites. The only thing in my filter is about an inch of cotton on each end with molecular seive in between. Here is the final configuration where I added the moisture indicator: