Tricky-Dicky's latest activity

I always find that making and fitting an SSG to most guns will quieten them down anyway without adding extra silencing, which shows that...

I have made lots of shrouds for various guns and no longer bother with back venting as it makes very little difference to how quiet the...

The small grip fillets don't constitute a fix to what I am looking for, just thought I would ask if some of the clever CAD design people...

Before I start trying to make a wooden or metal based grip I thought I would ask if anyone has done this as i don't find the grip very...

1/4 inch thread. 20 Pitch

What size are the four screw threads in the stock ? I am guessing they are 1/4" UNC, but what TPI are they?

Not at all! I just happen to know someone who had a batch made quite a few years ago and hadn't used them so he sold me one cheap for me...

LOL at the wind err discussion, you guys need to try .177 at 780fps and less in gusting wind, further to my accuracy problems I bought a...

I now have a new LW un-choked barrel on the way to try as I suspect a lot of my problems are down to the over tight STD barrel, the fact...

Try turning your dwell all the way down to 12 and see if it tightens up. That seemed to help when I was shooting at those lower pressures

710 to 770 depending on weight and HP 1200 LP 140, but as I said it's strangled to comply with UK law.

I was curious as to what size the unlimited valve seat/TP was in relation to the sub 12 .177 as mine measures at just 1.9mm, I have just...

Interesting! Out of interest what size is the aperture on the valve seat/pre transfer port, as I have found making a reducer for the...

The size of the outlet from the Valve seat into the manifold on the restricted sub 12 .177 is around 1.3mm so as I couldn't match the...

I used 2mm at the valve face end with a sort of taper to 5mm at the barrel side haven't got a taper drill of the right size, so it's...