Tricky-Dicky's latest activity

Well that was interesting, just put the gun back together with the manifold/TP reducer and only done a couple of 10 shot strings to...

It does. I just used my warranty and had the replacement scope in four days.

Thanks for that, (y) I will keep this posted as to my progress, I am still looking for a better barrel and will try sleeving the...

Electronic Dwell control just buys you ( In incremental terms ) a tad more valve open time when set to a higher value over a lower...

"Electric Solenoid dwell & Low pressure creates the opening cycle of the valve and some of the parameters of how long valve hangs open...

Yes should have said TP/valve seat, but generally It's what you're calling the manifold that would normally be referred to as the TP on...

So I am presuming that reducing the TP and barrel TP diameter would certainly help with air usage along with changing the size of the...

Thanks I'll give that a read, did you do anything to the actual barrel sleeve transfer aperture as well as reducing the TP tube size?

That said ... You may wish to do a re-read on my R&D done a few years ago that was going after better efficiency, reduced output pulse...

Yes I have had problems with my sub 12 Epoch, first was the barrel (and still is) very tight in .177, and I could barely rod a pellet...

Changed all mine out

Some of my guns have had 5K + pellets through them without cleaning, to me a good barrel shouldn't need to be cleaned on a regular...

Skout needs to do both Buna N & Polyurethane O-rings. There is no doubt that poly is better in some applications…….AND there is even no...

ya..that little o-ring gets clipped became very quick at replacing that one works better with the air adapter i believe you can also try...

Which tends to fail after very few operations, hence the question about using different O rings, as I would rather keep it pressurised. ;)