steve-l's latest activity

Never make a change to correct a fault you are not certain you have. That's what I meant about chasing your tail. The best way to rule...

The OP is chasing his tail. It is all about confidence in your gun. You must know between your ears that any observed fault is yours not...

Mark, Measure the pellets both head and skirt diameters and you will see that the skirt is larger than the head in any caliber...

Your understanding of the GK1's magazine is not correct. The GK1 and the K1 rifle is a revolver and in every revolver is the requirement...

I've read this thread front to back. You get what you pay for. This Reminex pistol falls into the same category as the Artemis /Snowpeak...

I understand your concern, but Your choice of sights comes down to your intended purpose. I am a very experienced pistol shooter and...

With a pistol I miss a lot, but even when I miss I am close enough to get their undivided attention. I don't use open sights. I use ...

No time, no matter what tool you have to calculate holdover at distance when shooting at birds. It is instinct and experience with your...

Yes, I have hit pigeons at 100 meters. To do that, I hold high about 30 inches. However, the GK1 is a pistol and I use my GK1s usually...

I must commend Weevil for his efforts. He is on the right track, but the limited space in the shroud available is a substantial issue...

Mark, Perhaps stating that your targets will not be distorted over time by soft lead pellets, would clear up any doubt that may exist...

I have never shot at AR400, so I cannot say how durable it is, but I can state that if mild un-heatreated steel is used, it must be at...

1/8" mild steel plates will be destroyed by .25 cal pellets at anything above 600 fps at 25 meters distance. .

Mattias, AliExpress for all parts including the 2mm reflex sight. My glass center to barrel center distance is 29 mm.

Cost and distance control.