Recent content by Shoothabreez

It's run about 10 hrs since the upgrades with out issue.

This is my cooling solution.

Thanks and yes. One screw went down through the Kydex plate & into that threaded hole in the 46 sight base. The other screw went up through the 46 sight base & into a threaded hole in the Kydex plate. I prefer the red dot mounted at the rear and as low as possible. It provides a slightly larger...

Howdy Gwelo, I traced an outline of the red dot sight onto a 3/16" thick sheet of Kydex. Once cut out & matched to the sight's footprint, 2 holes were drilled to mount the Kydex plate to the 46's rear sight base. Then 2 more holes were drilled & tapped to mount the red dot. Fortunately, the...

It was $100. Don't know if there's a left handed version.

I called Air Venturi (216-292-2570) and purchased it from Stacey in Cust Service. The grip is made in Finland and is a direct fit onto the older Baikal 46.

This listing has been renewed

This listing has been renewed

He has the 10rnd mag listed on his website: https://maplecustomproducts.com/products/aea-hp-varmint-magazine. He says NOT to use them in the simi-auto but they worked fine in mine by taking off the cover and rotating the rotor 1 additional turn against its spring. He probably doesn't want to...

After about 1000 rnds, my HP SS + would stop firing. During the firing cycle, at least 1 pellet per magazine would follow the bolt probe rearward, getting stuck in the hammer/trigger area. I finally discovered that a worn breech O-ring was to blame. After replacing it, flawless cycling resumed.

I copied your polish and spring tuning. That solved the heavy bolt hold open and softened the cycling. I also tuned the trigger to 3.5lbs, eliminated the creep and added an overtravel screw behind the trigger. The barrel really was very accurate with 18gr FX & JSB pellets. Around a tin of...

I can't say there's a favorite. However, the red dot & new grip did greatly improve the Baikal.

Selling my .22 HP Varmint Custom with a Utah Airguns installed regulator (set to 160bar). It likes JSB & FX 25.4gr @ 920 fps & does pretty well with 18.13gr @ 1070fps. Holds air indefinitely. The bolt & hammer are polished to cock smoothly & much easier. I've removed all the creep from the...

Selling my .22 HW100KT. It's in dang near perfect shape. No modifications of any kind. Walnut thumbhole stock w/no dents that I can find. All metal is perfect. No leaks. Comes with two factory 14rnd mags, 2 piece factory fill probe, smaller fill probe from Huma, tools to disassemble the air...

Shot the 300S Jr. today. What a joy. It fits & balances so well. These standing 10m targets are nothing to brag about, but not too bad for a 68 year old fart. The one on the right was going pretty well until the hasty last shot 😩.