Recent content by PopEye99

Still waiting... If/when it comes out will be determing if I buy a Wildcat Compact BT or not. Want something that won't require a Sniper barrel and heavy slugs (got one already) , close range up to 100m and I'm fine 😊

The gist of it you can. But I too would have liked it in .22 . No interest in "maximum power" etc, just embrace the high BC of .22 for long range shooting.

.

.

Oh, you mean it might just be a spare? That sounds logical, two of them wouldn't fit in there. Thanks, I'll have a closer look 👍

That's the large o-ring, there's a smaller one too. And as I suspected, I got too much pin sticking out to get the magazine in. Ernest just screws the pin back accordingly but there's no way that pin is going to stay where it should be. I guess I could just locktite it in place. .

I'm about to install my pin probe and I'm feeling a little bit stupid here … There's a smaller o-ring that I have no clue where it should go, on the pin I would suggest but there's no way getting the pin in with the o-ring on. With no o-ring I would think the probe will not stay where you leave...

I'm about to install my pin probe and I'm feeling a little bit stupid here ... There's a smaller o-ring that I have no clue where it should go, on the pin I would suggest but there's no way getting the pin in with the o-ring on. With no o-ring I would think the probe will not stay where you...

Yes, most sites has them, baraluftvapen, cabom, rodastjarnan osv. Take out the piston first and see if you have the bleed screw. Hatsan is more complicated than a Weihrauch or a Diana but not that much. Check out Mike Ellingsworth on youtube, he has guides on taking apart Hatsan and on the...

If it's not overfilled and the only thing that's stopping you from bleeding it (providing you have the bleed screw) just take the piston out of the cylinder and bleed it.... But ,as I wrote earlier "My guess is that they gave away with the bleed screw on the Swedish 10J/7.38 ft-lb version, the...

Thank you, hopefully I will never have to do it again.

Following the same procedure as "mikeyb". A drill guide for the drill, an impact resistant screen, 3m rope, and I had my motorcycle helmet on. I rigged everything up this morning, but kept putting it off, quite a bit nervous. I finally gave it a go .... As mikeyb said - what an anticlimax...

Following the same procedure as "mikeyb". A drill guide for the drill, an impact resistant screen, 3m rope, and I had my motorcycle helmet on. I rigged everything up this morning, but kept putting it off, quite a bit nervous. I finally gave it a go .... As mikeyb said - what an anticlimax...

I followed Gerry52's link with the slow bleed (some posts up). In order for the valve to open you have to have slightly higher pressure than in the piston (or the receiving end), that's how I ended up with 280 bar. It was 270, got slightly above and slowly releasing pressure in hope of the...

There should be a bleed screw on the other side on Type 2 piston, I got the hole (in the cylinder) on the other side but no corresponding bleed screw on the piston.This is what mine should look like https://youtu.be/-WUrYNfZ_n0?t=63 . My guess is that they gave away with the bleed screw on the...