Recent content by Other_Mark_B

Great point to bring up. Moreover, Sig stood up and made the marketing claim a reality for me when they replaced the gas ram and ram seal resulting in near 23 ft/lb performance (a 1.27 ft/lb increase) when they could have just as easily used the "up to" marketing claim to ignore my concerns...

Question for Tony B, if convenient to ask Can and will Daystate release a revision to the Powerset Programming instructions that is targeted toward owners with programmers rather than Daystate engineers? Thanks Best wishes. The other Mark B.

I'm looking at the feasibility of coyote hunting. I have a Redwolf HP in .22 that makes 49 ft/bs. Will that humanely end a coyote if I keep the distance to 50 yards (if I can even call one in that close)? If so, is there a particular pellet I should tune the gun for that will work best at...

First the back ground. Chronographed rifle with multiple different pellets. Never exceeded 21.85 ft/lbs (and that was with H&N sniper Lights at 14.94 gr). I contacted SIG customer service (CS) to see how I should proceed. CS spent lots of time with me and with acting as the go between with...

I actually had a crow sit on the ground between me and my target box. I did not want to accidentally hit him if he took flight as I was shooting so I put a few in the dirt next to him to get him to move off. He just ignored the first few shots. Best wishes. The other Mark B.

And a bit more with tax and such when you walk in to AoA, so it appears the market rate is pretty well set. Best wishes. The other Mark B.

Just the rear screw as far as I know, but customer service can advise for sure. BTW: I just unboxed the rifle and read the packing slip. SIG also replaced the piston and seal when they had the rifle. So it appears that they put substantial effort into my customer service request. Best...

Resting the ASP20 I forgot to add that rifle stock sits lightly (that is gravity) on a Protekor rear rest bag. Best wishes. The other Mark B.

RE: Results from SIG The engineers at SIG believe that the elevation difference accounts for the lower ft/lbs results I was getting. Basically, they took the gun apart, inspected it, reassembled it, and test fired it. The gun was just delivered so I need to unbox it and test fire it with...

My .22 ASP20 has been out for two weeks and won't be back from SIG till tomorrow. That being said, I too was having accuracy issues. From what I remember, a firm grip while holding the gun loosely in my shoulder combined with resting the front of the rifle just ahead of the trigger guard worked...

If I recall correctly it was provided somewhere within the 24 pages of the "Daystate Report" post found on this site. Then it again it may have come up somewhere else. Kudos to whoever went to the trouble to get access and to make it available to the rest of us. In any event, here you go ...

You personally could tune the rifle to three desired power levels as often as necessary so that the final result is highly optimized for your rifle and shooting conditions, or you could have AoA do it once for about 1/3 (plus or minus some) the cost of the Daystate Powerset MK2 Programmer. As a...

Unfortunately, the Diana Zero Recoil mount fits dovetails rather then Picatinny rails like those on the ASP20. Best wishes. The other Mark B.

Check out https://www.creedmoorsports.com/product/1753/sale Scopes are not a problem. My cases fit AR's,RAW with bench rest stocks, and Daystate Redwolf HP (unscrew the suppressor) rifles . You'll need to measure the length of your rifle to see if any of the cases are long enough. Best...

RE: Factory return I got an RMA number and FedEx label from SIG via email. As some may recall, my chronograph numbers match neither the factory specs or Tom Gaylords findings. I dropped the gun off this morning at FedEx. According to the RMA email, I can expect a turn around of 4 to 6 weeks...