nervoustrig's latest activity

Accurate and inexpensive is a tough combination. Most of the low priced pellets I've purchased over the years have been disappointing...

Shot count is on the low side but it is highly dependent on both temperature and manufacturing variables. Pretty much always going to...

If the plan to install an aftermarket regulator falls through, measure the Belleville washers with calipers and see about installing...

If you are contemplating replacing the barrel I see that as an opertunity to learn and trial and error. I would try one step at a time...

Good news, that will do nicely. Just make sure it is a true round head, not a pan head.

I do. The workmanship of most airgun barrels leaves something to be desired. Inexpensive ones particularly so, and frequently even the...

Tim will take good care of it for you. It sounds as if there's a problem with the pump cup. It's either no longer sealing or has come...

Her sons are grown up and out of the house. The coyotes are her children now.

Yes, both aspects are specifically related to regulated airguns.

Relatively small cant angles can produce meaningful error at 100 yards due to the loopy trajectory of pellets. For example, a gun...

This effect is usually indicative of having a little too much hammer spring tension. In other words, the gun is operating up on the...

Please bear in mind that any scope mounting strategy which starts with a spirit level to level the gun is making a variety of...

Thanks for the answers guys, On the Mk1 the probe is not adjustable. So I pulled the barrel again and this time fully removed the...

I only had a few different slugs on hand at the time, but mine would not group H&N in either .217 or .218, nor the FX Hybrids. Not even...

Good example. I had something similar happen once...a gun leaked down to the point where the hammer pushed the poppet open and sent a...