nervoustrig's latest activity

Over the last several years have put this THEOBEN RAPID Mk-2 up for sale in the forums and offered it at club swap meets too. Folks...

The new pellets made in Spain are starting to appear...

Mike detailed how to recognize it here: https://www.airgunnation.com/threads/polish-an-lw-polygonal-barrel.1324826/post-1880370

If you get a LW barrel on a Daystate, RAW, etc. that doesn’t seem willing to deliver tight groups, check for the common potential...

I agree, I think it's a compromise for an aesthetic. I just put calipers on mine to confirm the 20mm measurement, but I wanted to...

It doesn't have six flats?

The end caps on mine were tightened like grim death. An open end wrench would not break them free, and was succeeding only in damaging...

In your original post you described pushing a pellet through it both ways, which I interpreted as fully through both ways. I was...

The usual suspects would be a burr at the barrel port or a very tight choke. Try pushing a pellet partially in from each end, then back...

Centering is achieved by moving the drill in an orbiting motion. If instead you try to hold it still, a bias will inevitably develop...

If you do decide to replace it, look for one with a pin type check valve. The ball type, at least the one in the Avenger, isn’t the...

FYI, illuminated reticles are very visible through the objective lens when used at close range. I figured out that mine was spooking my...

The good news is if it’s leaking fast enough that it has lost all or most of its pressure overnight, the leak will be easy to identify...

90's is good? You must not have the malarial type heat we have here. Mosquitos, ticks, deer & black flies are loving it. The woods are a...