nervoustrig's latest activity

May it bring you results that can be described as divine.

I was being silly. In reality, having an O-assortment on hand has proven valuable on many occasions. Well worth the price even if I...

I’ve purchased several O-ring kits over the years. They’re great for having a wide variety of O-ring sizes except the one I need.

Just have to say your disposition is refreshing. The world needs more of you. Especially the online world.

So I think you’re right. I thought it was a juvenile collared dove. When I saw the footage I saw what looked like spots and was...

Nice shot and good scope cam footage. Friendly note, that looks like a mourning dove and if you’re in the US, taking them with an air...

One guy’s opinion on crowning…I use the lathe for the facing cut in preparation for crowning but I prefer the brass screw approach for...

One can achieve very good results with a basic $500 mini lathe. The end result is about 40% setup, 30% technique/workmanship, 15% a...

The O-ring pictured seals against the undamaged side, however I would use a fine rat tail file to clean up any burrs to ensure the...

Just FYI the part I referred to as the piston and Scott referred to as the spool is the brass part on the left side of this picture

Nice shooting with irons at 50y! I had pretty much the same experience with the 9.1gr domes vs the 8.4gr. The 9.1gr group nicely from...

Possibilities that come to mind: Damaged O-ring – When the piston cycles, the O-rings break free momentarily and then have to resettle...

Pressure creep is caused by surface imperfections in the regulator's valve seat (wear, or damage, or machining marks). Many times it...

Hi Folks, I’ve been working for a while on solving the slow first shot issue in the FX DRS. I’ve done various tests and tried different...