monstr2's latest activity
- Mmonstr2 reacted to Ninjababy's post in the thread Tuning FX Impact Reloading block issues with
Like. THIS ☝️☝️☝️☝️☝️☝️ - Mmonstr2 reacted to Elbowgrease's post in the thread I need Ernest Rowe's help for impact's problem!!! with Like. Yep. This is why I will not spend my money on an FX. FX just cannot deliver quality products.
- Mmonstr2 reacted to edosan's post in the thread I need Ernest Rowe's help for impact's problem!!! with Like. You mean 48 grain? 48 grams is too much! ;) (740gn!) That should not be a problem on an impact considering a 51gn pellet. Is weird...
- Mmonstr2 reacted to Tony_Du's post in the thread I need Ernest Rowe's help for impact's problem!!! with Like. More information, my impact barrel is 600cm, and wight of pellet is 48 gram, all the three pins works fine when the speed is lower than...
- Mmonstr2 reacted to gadballs9's post in the thread I need Ernest Rowe's help for impact's problem!!! with Like. And these things cost HOW much? Must be nice to be used as a FX lab-rat. Seriously, how does this crap make it out of the factory? Are...
- Mmonstr2 reacted to Tony_Du's post in the thread I need Ernest Rowe's help for impact's problem!!! with Like. Dear Ernest, My Impact is .30, and the barrel is 600cm, as the picture show, i broken the cocking pin, and then Edosan sent me the...
- Mmonstr2 reacted to knifemaker's post in the thread How to deal with Impact barrel locator pin with Like. Well, FX is wrong. It may not be by the typical home tinker, but anyone with a mill and a carbide end mill the correct size set at high...
- Mmonstr2 reacted to rappert's post in the thread Cocking lever opening during shot FX Impact 2 with Like. I had the pin break in the reloading block, and it had nowhere to go so it was still stuck in there and the cocking lever still working...
- Mmonstr2 reacted to heavy-impact's post in the thread Cocking lever opening during shot FX Impact 2 with Like. The rubber ball is missing from the front of the reloading block or you have a bent pin at the block. I haven't looked at one in a long...
- MAnother one bites the dust...
- MTwo hard rubber balls in the cocking block will keep the handle somewhat under "tension" when closed. But I have the flat bar flipped...
- MIf your cocking arm is popping open too easily, your probe block and seating depth isn’t adjusted properly. This is one of the first...
- MHas anyone come up with a good solution to keep the bolt handle on the Impacts in the forward position while hunting and moving around...
- Mmonstr2 reacted to moinsen's post in the thread FX FX Impact M2 reloading block shift while cocking with Like. There are known issues with the gun but the problem in this dimension occurred yesterday after changing the spring. Actually one of the...
- Mmonstr2 reacted to moinsen's post in the thread FX FX Impact M2 reloading block shift while cocking with Like. I have quite a headache with a used Impact M2 I bought recently. Yesterday I installed a new hammer spring and noticed a scratching...