Recent content by LR_Plinker

These may help - you remove the butstock from the tube by pulling straight down on the adjustment lever and sliding it backwards - it should pull right off. The "tops" of the tubes turn to release them from a slot in the stock. They won't come out when the stock is on the tube, as the tabs hit...

I think if you remove the butstock from the main tube, you can turn and release the covers on each side tube.

You won't gain anything by turning up the Huben bottle reg. It is actually good to have it set close to the guns set pressure of 2050psi, as the guns reg won't have to work so hard. Leaving it where it is is fine, too - the Huben allows you to fill the bottle to higher pressure - many of the CF...

I had not seen the bad experience(s) until right after I placed the order - figured I would give it a shot. It was a bad idea on my part. As mentioned, at least I have one in hand that I am enjoying - I will eventually get the second, one way or another.

Be warned - DO NOT ORDER FROM DACKS! 45 days with no communication at all. Finally I got a notice that my order was "in processing - but this does not mean shipped". They were unable to provide a timeframe for actual shipping, so a refund was requested. 5 days and counting since a full refund...

I've got 1 .25 I have been playing with for a couple of weeks, and should have a second inbound (if DRACS actually ships). Plan to have one set up for pellets and lots of plinking, and one for heavy slugs. I added 4 asymmetrical baffles to the shroud after adding a couple of small vent holes at...

0.2" is 2/10ths, or 1/5th of an inch. If easier, in metric it would be @5.0mm

I am new to this conversation, but I have been playing with a .25 Zelos for a little while now. The biggest improvement I have been able to get out of the gun came after I changed out the valve spring for something softer. I also made a new spring adjuster, but the same results can be had from...