Kenjeepman's latest activity

Is it the reading or comprehension the issue with some people? I HAVE 2 GK1’s, actually 2.5 if you count the .177 barrel/mag… but i...

Interesting, something i should of done way back. Swap the calipers over. Ran the 25 cal barrel/mag on the 22 block. 22 cal as is 30...

Yea ok.. just deal with it .. a $1500 gun smh.

It does have the notch on top if that is what you’re talking about? Too late .. black o-ring installed. Tomorrow will see if my theory...

I have a theory. First valve i removed had white markings in 3 spots from the o-ring. The 2nd valve was removed and it was sticking...

Heres the 25 for comparison 1-17 i mag 7 fps spread (ok so there was 1 817 that i removed so 11 fps) haha Highest it went to 854 or 44...

No dice.. did extremely well through 1 mag 10-14 fps spread. Next 10 almost 62 fps or almost 80fps including first magazine. This was at...

If the valve swap doesn’t work, the only thing i can do … not to fix it but prove theres a issue. Swap the barrel/mags on both with each...

New valve. Same as with the one i lost.. its chamfered so you dont get that circular imprint from the washer. No vent/notches .. got my...

25 cal with 25 grain pellets at 40 fpe 1 mag 9-10 fps spread 2 mags 25-30 fps spread. 22 cal with 25 grain pellets at 40 fpe See pics

Valve washer back in. I also lubed up the pin again. Same results as before. First mag ok 2nd almost 70 fps . Oddly first mag went from...

Ahah makes sense. Removing the washer reversed the curve. went from 819 down to 775 then up to 840 for 3-4 shots before dropping again...

Heres the difference. Striker is deeper on spring side. Also no black buffer plug on vlave side. Longer spring. Valve itself is all...

The stem was lubed when i had it apart previously. I added washers to add lenth to the spring because the seat is deeper in the v3+...