Kenjeepman's latest activity

It started to slowly let out all the air after a shot. Reset the striker 3 times before taking it apart again. Brand new v3+ valve was...

So i noticed the latest closing valve is tapered on the bottom. I did install it and dry shot once and then it dumped on the next shot...

Just got in a replacement AEA compressor. 1st one sht the bed. Awesome its a 110v version and i no longer need the converter box. Also...

This is with 22 gr pellets. Bumped up to 35 fpe .. 5k fill. 1 mag with only a 11 FPS spread. Shot 20 was down around 23 mpa. As you can...

Not sure why the pic didnt post

almost got it .. whoever designed this Gun is Einstein level genius lol I have 2 GK1’s, a 22 and 25, both v3’s but the 22 now has the...

Theres 2 springs, what spring is responsible for closing the valve ? I put the new v3+ valve, spring, etc in my GK1, gregor said the...

Absolutely

Have not heard of that. Are you talking about misalignment of the barrel and the mag? I can see if that were the case it would damage...

With pellets you should be ok 600-700 fps Do you own a chronograph? I have both 22 and 25 Gk1’s. I can not use the hubben moderator...

You using a moderator ? Clipping .. thats the only thing i can think of with groups that big.

Ty

hes been helping me along the way, hasn’t mentioned it.

Knurled area of slug measured .179 which is the mag minimum. Pushing it through the barrel it mics up right at .177 confirming the...

This will be the deciding factor. I developed the utility knife blade knurling so I could keep the knurling consistent. It’s not some...