JimD's latest activity

I had to remove the regulator in my bullshark today and you are right, it is a smaller brass valve. I measured it at 6.5 mm diameter...

My first P35 was a P35-25 caliber and I was recently gifted a P35X in 25 caliber that was not shooting right. I have not fixed it...

Especially for heavier slugs I suspect you will want to use 160 bar or possibly even higher on the reg. It will cut down shot count but...

Well I have what I think is an interesting target for the spreadsheet. I shot it this morning in what the weather report says is 8mph...

3rd day at the range this week. I’m about ‘ranged out.’ Lucy is too😂😂😂 Have not shot the Daystate Huntsman Revere in a while...

We experienced weather conditions today almost as good as yesterday except for wind speed which I would guess was in the 1-3 mph range...

Returned home this afternoon around 4:30, retrieved the mail and suddenly realized there was only a very slight breeze blowing. Dumped...

Went to range this morning and shot five 30Y Masters cards; one flag at 10Y from muzzle. Wind very light at start and only 1-2/3 mph a...

That's interesting. I have a bullshark now too that I think is more recent manufacture. I changed the regulator on it but I don't...

A 150 fpe 35 caliber would put the hurt to a coyote. Probably shoot right through it on a body shot. With a big enough hole it would...

I may have said this before in this thread, I apologize if that is the case, but the nice picture in post 102 causes me to raise what I...

I have no experience on FX but to set the parallax you get the gun set in a rest on the target and then without touching it move you...

Actually the P35X I am working on has a different valve (brass and 7mm in diameter instead of plastic and 8mm) and a different hammer...

There should be a screw on the fitting on the back of the air tube that is the bleed screw. On my first P35 is it a straight blade...

John, I have a Yong Heng I use to fill a 45 minute (66 cubic foot) SCBA tank. I usually fill my guns from it. But I recently bought a...