JimD's latest activity

The best evidence of regulator failure is the shot curve. An unregulated gun will often start lower in velocity, then rise as pressure...

If you just want to shoot you may not need to go anywhere. I am in Lexington (but not the town of Lexington) and legally shoot in my...

Welcome to SC. I don't know of a place but my son lives in Rock Hill. I'll ask him. You will be close to Charlotte.

That is not a proper place for a vent IMHO. I used my CS2 to fill a Bullshark from zero today and it worked fine with my plug in place...

I have no Leupold experience other than looking through a buddies. It was nice. I had to send my Athlon 10-40 back to them when it...

I do not have any scopes that cost more than $330 new but I have several I really like. My Arken EP4 6-24 was $330 and it is a nice...

Took the Taipan Vet2 700mm .22 caliber with me today. Wind light again today at the start at 9:20 am. Shot six cards. Three 30Y...

You don’t need to spend much money on a scope to compete, a good Athlon or Hawke will work nicely…. I only have pricey Airgun stuff...

Hello all! Another new member here. Been into backyard plinking, trap shooting, and varminting off and on for many years. Back of my...

I don't think it makes much difference. I lost one of those little pins the first time I took it apart and just pulled the other one...

I took the tiny little absorbent filter that was inside the metal block of the CS2 under the pressure gauge out when I put the much...

Yeah, the sole purpose of the one I use is to keep anything but water/vapor from getting to the sieve filter.

My fix is deliberately not permanent. I let the epoxy on the washer set up before I put the washer under the inspection port. The...

I was finally able to convert my FX Impact to a true left hand gun! The magazine now inserts from the left side thereby solving cheek...

Yes, the port with the hole is how you remove the wrist pin. I did not measure the removal force but it was more than I could put on a...