JackHughs's latest activity

I'm going to make a huge guess here. I have a CS4-i. MY shutdown procedure is to close the tank valve and then use the compressor...

Hi, It appears that best way to fill these cartridges is directly from your compressor. See JackHughs

In theory yes. However if you do use a regulator then all the cartridges will be at the same pressure and you will have more consistent...

If you want to fill the cartridges to 4500 psi, you don't need a regulator, just a fill valve. I don't know anything about the...

Hi, The referenced power supply is not a GX power supply. It is a generic, general purpose 12 volt 600 watt power supply. My friend is...

Yes this is true. Crosman/Benjamin can not sell compression chamber parts to the public going forward. This also includes PCP. This was...

Adapter..

Thanks, The 12 volt external power supply will stay on the shelf unless needed for emergency use, such as failure of the internal power...

I get 13.5V using a dead head on the external power supply. This is on a 25 year old radio shack analogue meter that's very accurate.

You beat me to it. I had planned to ask if any of the forum members would please measure and post the the output (under load) voltage...

Uodate: I have a CS4-I that worked properly right out of the box. So far, so good. As I mentioned in a previous post, I purchased a...

I agree. Check the alignment of the transfer port in the barrel with the transfer port in the action. Also, this rifle should have two...

There is a thread somewhere here where someone found some burnt out electrical parts on the inside and was able to fix it. Just in case...

Thank , I have a gallon of the Seco Lube 500 on the way. $146.28 total shipped from KG power systems. I only used the RP For the initial...

You have a CS4 with an external power supply, correct. A friend has a CS4-i with a bad internal power supply. He bought this power...