Recent content by GTSdvr

My CS4 was working fine last time I used it about a year and a half ago, has maybe 6 hours on it. I just fired it up again after changing the coolant and cleaning the check valve. It's getting to about 200 bar and stalling out. If i don't hit the off button in time it's shutting off the 12V...

Thanks guys, I did use distilled water / water wetter when the unit was new. What's involved with checking the grease? I remember giving it a turn after the first 4 hours. Is it just a matter of pulling the grease cap and checking how much grease is in there? I also checked/cleaned the...

I purchased a CS4 in 23, did the recommended maintenance after the first 4 hours of use but since then it has sat unused for about 2 years. Before I fire it up again any advice as to maintenance it may or may not need after sitting that long?

Based on this image Zach sent me he should have plenty available. Ready for the finish.

I was thinking about giving the BSA a try as well. The Burris 2X is decent, owned one in the past.

NE airguns says they don't know when they will get the adapters from Huben so I'm in for one as well.

Has anyone tested the range in full turns on the power screw from closed to full open. I'm assuming the power screw should mechanically stop at the point it is fully open? (and not fall out o_O).

Uh-Oh that means stealth mode in the backyard for awhile.

Mine is on the way from NE as well. They emailed that the moderator adapters would be mailed separately.

Yep New England got a crate full of them. Hopefully I'm in the first batch.

I'm going to start with this. Hard to go wrong for $60. I've got a Burris pistol scope on my Ruger Blackhawk I can try as well.

I decided to roll with the Huma MOD30 after seeing FLgunner's setup. I like the modular design and I'm running a red dot so sight clearance shouldn't be a factor. Now to find a good bag for it, not a fan of the hard cases.

I cancelled my preorder with that Spanish shop and kept my pre-order with New England. Less expensive over all and don't have to pay in full upfront to get the "discount". They emailed me and expect their first shipment next week.

What's everyone thinking for a suppressor for the GK1. I've got a DonnyFL Fatboy I use on my rifles but I think it might be a bit big. Want a balance of functionality and looks.:cool:

What's the consensus about these? Wait to see if the current offerings fit the pistol? After reading that last post link it looks like the interface to the stock varies and the pistol could be different as well.