Recent content by Ghulam

Greetings All, I recently got my fx mk2, PP version with 700 mm stx barrel. i would like to tune it for jsb redesigned 25 gr pellets. let me know your best settings of reg, power wheel and micro/preload.

I have seen many parts, especially regulators badly corroded due to moisture. the filters wont hurt anything. moisture may also damage orings. i am reluctant to take apart pcp, it is a tedious work.

i hope u r ryt. Whether it flows to vessel the moment compressor starts or build the pressure first. It seems impossible to me, that a filter material can hold water under that much pressure. An airgun usually have 100 bar, so the compressor would start pushing to vessel @100 bar. Even at that...

Every filter has some kind of cotton, foams, cahrcoal or a desiccant and these tubes supposed to filter water and oil.. when a compressor pushes air of 250 bar pressure through this tube, how a desiccant decides to hold the water under that pressure but let the air through?

what if i add more orings evenly spaced, instead of cf sleeve.

Hey Guys i would like to know what are the max fps of the following guns with 18 gn JSB, and are these guns good for slugs 1. FX crown with 380 mm barrel .22 2. Uragan .22 3. Brocock bantam Sniper HR Cheers

I haven't used the mk2, but my SE is a very fine thing. The stock tench regulator may not match Huma, but its performance is not offensive. 

hi Odoyle! there is more in the story. the sudden drop from 855 to 840 was probably the break-in of the regulator after service. With the second fill, I got 80 shots with avg. fps of 844 and es of 17. Per shot air consumption was 1.2 bar. now I am very happy with it.

Got my attention, can you explain further. How exactly and mathematically you do it..

Awesome 2284.3

I will share my experience with Hatsan neutron star here. I only had one choice - jsb knockout 25gn in .216 heads. Didn't work for me all the way from 820 fps to 920. They were still wobbling and terribly spiraling at 920. The 830 mark was a bit good though. I tuned it again for jsb 18s at 900...

Dear r10 se owners Recently, i installed 350cc cf bottle on my r10 se and played with reg( tench) and hst to get my desired 850 fps with jsb 18. I achieved it. The consistency and accuracy is amazing. I am not even a good shot but still it was .4 inches at 75 yards. I Screwed the reg full max...

Hi Odoyle I finally fixed it. Regulator block orings were also charged. Then started turning. I cranked the reg to max and the loose it one full turn. Also adjusted the HST. Fired 20 shots over chrony and with es of 7 my avg was 855 fps. I also tracked the air consumption. And after each 5...

Yes, i tried it. I observed the bottle oring was not in good condition. So i ordered a few. Hope they will fix the problem.

That time i finished installing 350cc cf and was hoping a little high fps with good shot count. But the reg and then the valve didn't wanted me to enjoy it. Now i m back to office and will work on it during weekend. Meanwhile will be looking for suggestions. Thanks