bubbahotep's latest activity

Easy hair trigger upgrade, remove trigger spring, thats all! Adjust the existing highlighted screw inwards to further reduce trigger...

This $20 black one is one piece and 1.3mm instead of 1mm like blue from my measurements. and is one piece instead of bolted...

Couldnt resist getting $400 semi auto pistol threaded for silencer for $255 refurb with the freedom20 20% discount code...

Buy whatever thickness springwire and wrap around a bolt of the same pattern. Drilling a hole near the bolthead to hold the start of the...

pretty much should i inspect tank everytime i need to change media. With normal earth physics id expect it to dry eventually or even be...

If noise is a factor bare in mind that many of these airguns being mentioned will need the bark tamed as well.

I'm running a GX filter with a tampon filter afterwards that i check to see if its moist as a sign to change the filter media. It hasnt...

Silica gel on input is pointless. A perfect setup wont even get within 100 degrees of the dewpoint needed.

$265 for Snowpeak T-rex carbine, regulated .22 230cc 3600psi tank, 26fpe/35j @ 900 fps w/ 14.3gr. It's a hunting gun not a dense suburb...

If you got that 50mm spring then I would do the shortest m5 cap head at Ace (m5x8mm like I found) and some 1/4" thin washers to stack (i...

Got my target rifle and targets to be quiet enough that some deer decided to nap in the middle of the range.

Going to try this 9x1x60 mm spring https://www.amazon.com/dp/B09LV363YZ 2-3 week ship time tho. SAE equivalent or cutting down a long...

Cap head screw raised fps to 400, max with washers was 500 fps before sear wouldnt engage. That spring is too small/weak. With the...

Hysteresis, if the plenum is too large the pressure wont drop enough on every shot to open the valve to refill the plenun.

M5 socket head cap screw can slip onto the end of the spring and into the hammer and would add 5mm to the 50mm spring length. Spring can...