bubbahotep's latest activity

50mm spring was too short. Got 250 fps with screw all the way in, screw all the way out was so slow the pellet got stuck in the...

Milk plastic PLA https://www.printables.com/model/756519-target/files

Theres Ebay vendors selling 3d printed pellets. They tend to all look like this.

Dry bike chain lube is wet and dries leaving wax behind. Below 900 fps you dont need to lube to avoid fouling. Above that I would use...

Guess I'll try these $5 next day springs. Stock is 9x1.1x60, these are 9x1x50, I couldnt find any 60s on amazon...

Why would a bigger plenum be involved with lowering power? Oversized plenums reduce shot consistency I hear.

Tall part rotated 90 degrees on the bed will lower bed movements. Print one item at a time or itll leave a scar where the shorter part ends.

12v water pumps must use some kind of switching circuit if theyre just coils and a magnet impeller. If ran dry the impeller bushings...

Bought a 1.8L buddle bottle new, 4500 psi working pressure, DOT paperwork confirms it but it uses a 5k burst disk. Im sure ill get a...

I had to go into store. They restocked with the green label spain Crosman 22s in last month.

$123.51 https://www.amazon.com/UTG-Bugbuster-3-12x32x-Mil-Dot-Rings/dp/B07HRM5T1G Might not fit in the case with it but you can add...

Yeah that mag will work better. Downside of using the open face mags i was using is that you have to push every pellet but the first one...

I think you are mistaking a 3/8" BSP (9.5mm) for a 10mm.

3/8" lasso? is metal, the picatinny ones are 3d print.

put some foil or soda can pieces under the back scope mount.