BriarpatchMtn's latest activity

You can find a multitude of threads here about moisture control, and filtration methods. We all have to deal with it. Environmental...

Mine has the plastic valve, didn't think to measure it. Hammer Spring is the weak link it seems. If I turn reg up even another .25mm...

I have a scout in .25. The ranger in .22 should be awesome. I love my scout.

My GX CS4 says 99.3hr, probably 100 since ran some before installing meter. Lots of direct filling a big bore at the range, and plenty...

Mine is 25 cal. Lots of pellets on the market to try to find a really good match. Thus far it's seems the H&N Baracuda's 30.86gn group...

@JimD Got the Shark regulator tuned best I can. The long reach from the muzzle didn't work, reg screw would turn when tightening the...

Found the clamp. All in one piece. Obviously not pinched sufficiently. Was about 25 feet away, through the gate and down the driveway

Compare with post #20. They're similar but 1st gun had some tuning before I received it. This one's out of the box factory. And by the...

Thanks for the advice. Did little with the crono after seeing fps simply went down as I back hammer spring out by 1/2 turns. Tuning this...

Got out with new gun this morning before rain arrived. Sight in was with the JSB's at 25 yds. Believe this one will also like the...

The valve of the bullshark is smaller diameter and brass whereas the P35 poppet is plastic and bigger. But the P35 hammer spring cannot...

Thanks for the how to. From what I gather all the XM1 series come with the regs set at 150. I figure that at some point I'll be...

Thanks for sear adjustment screw size. Wonder if they've started omitting them intentionally. They're not mentioned in the manual, only...

New Bullshark .25 arrived today. Got to give Benelli/Stoeger credit for standing by their warranty without any hassles. Shipped...

honestly the fact that this is made by AEA would make me hesitant. I have never seen as many QC and design issues and had so many...