BriarpatchMtn's latest activity
BriarpatchMtn reacted to rcs9250's post in the thread Trying to research and understand which types of filters are preferred and where best to install them on a new airgun compressor. with
Like. Some folks will say that they run their home compressor in the basement of an air-conditioned house. Even with air conditioning, the...- BriarpatchMtn replied to the thread Filter valve when not in use.My setup is a bit different because I deal with good bit of humidity so I went a bit over kill. Because mine takes alot of air I leave...
- BriarpatchMtn replied to the thread N/A Moisture in PCP airguns.That's mine. Compressor is below the filters for bleeding line and moisture trap in compressor after each fill; first filter has one-way...
- BriarpatchMtn replied to the thread This hose made it exciting.Had one similar blow out under the braid. Wasn't near it, but still probably jumped 2 ft off the ground. Upgraded to several linked GX...
- BriarpatchMtn replied to the thread Dessicant.Not tech enough to copy links. In the PCP forum there's a thread, Moisture in PCP airguns. Page 2, post #35, explains things in good...
- BriarpatchMtn replied to the thread N/A Moisture in PCP airguns.I'm most likely to be out at my range in the early mornings when the dew is still on the ground and dew points are high. No neighbors...
- BriarpatchMtn replied to the thread N/A Moisture in PCP airguns.New to pcps early last year. Living southwest VA, direct filling with a GX CS4 by itself got water in my gun. Regulator went wonky after...
- BriarpatchMtn replied to the thread GX CS4 'O' rings supplied with new compressor..The rubber diaphragm in my grease pot developed a split after a few hours of run time and piston pulled in alot of grease. Found on here...
- BriarpatchMtn replied to the thread One way valve for filling scba tanks..If they were available 1 1/2 yrs ago I would have gotten the GX fitler first. Probably would have been good enough. But I do tend to...
- BriarpatchMtn replied to the thread One way valve for filling scba tanks..Better safe than sorry. Moisture cost me a regulator in the big bore. Then I bought the tank, and other guns. Don't have or need A/C...
- BriarpatchMtn replied to the thread One way valve for filling scba tanks..I went a bit of overkill on my filtration after getting moisture in my guns, no worries now. Did a simple male-male one-way fitting...
- BriarpatchMtn replied to the thread Stoeger Updated Warranty Replacement for XM1 Bullshark Arrived From Benelli Today.Update Contracted manufacturer, Benelli/Stoeger, about warranty on barrel yesterday. Was asked to email pictures, and proof of purchase...
- BriarpatchMtn replied to the thread Home made projectiles?.Casting was definitely another rabbit hole after getting a big bore. Improvised ventilation fan in shed window, building PID controller...
- BriarpatchMtn replied to the thread Stoeger Updated Warranty Replacement for XM1 Bullshark Arrived From Benelli Today.Really got to wonder how they can get 99% of a barrel right then frig up one spot. Of course I work in a furniture factory and the...
- BriarpatchMtn replied to the thread Stoeger Updated Warranty Replacement for XM1 Bullshark Arrived From Benelli Today.Got to order more, only got one tin of each. May try a few other brands, but H&N varieties mostly.
