Recent content by BlackICE

If you have a 3d printer that can print TPU then... https://www.airgunnation.com/threads/gx-cs4-rubber-diaphragm.1317557/

When filling tanks I filter 3 places not including the compressor's purge system. 1. Regular household compressor to 150 psi. The compressor tank is the 1st filter. 2. Compressor output into 2 QT of silica desiccant at 80 psi, 2nd filter 3. Regulated output to 3 psi feeds into a CS4. (CS4 as...

I wonder would it work for raccoons and rabbits?

Put some IR /motioned triggered webcam out there to ID the critters and alert you when to lock and load.

Not everyone using the Forum lives in the united states. Also even if you live in the United States there may be states and local laws that may prohibit the use or ownership of and airgun moderator. Amazon takes such a cautious approach as well not shipping many items to some states even though...

Andy Grove - "Only the paranoid survive!" I also would like to restore the open air gun moderator discussions as well. I have learned a lot about the topic from them. However I also understand sometimes the risk / reward ratio combined with being prudent would lead one to the conclusion that...

diy, got the tube from Amazon and 3d printed the rest.

Aren't the reduction gear set on the motor also a point of failure on some CS compressors? I've seen some posts where the larger gear had the teeth worn out while the smaller gear on the motor survived. I would think it was the opposite since the smaller gear has a lot less metal to wear down...

I have interest in a Slash but will wait for really reviews from hopefully non-biased real customers before buying one. Too many guns are released too soon with design or manufacturing flaws that are fixed after the 1st production run. I don't want to pay top $ to be a guinea pig beta tester!

Yes, bulletproof vest, Kevlar pants, helmet, safety face shield and Kevlar gloves.

This 3d printed feeder is modeled from a dog proof. Gives one the option of thumbs up or thumbs down. I lengthen the spout 2 times to get it long enough so that skunks can't clean it out. I would hate to deal with a skunk stuck in a dog proof.

Be careful dog proofs also traps skunks!

I don't bother to unload the magazine. But I rotate the magazine so that there are multiple empty chambers if I accidentally pull the trigger.

The large oval one from Subscriber works real well.

Seems like a great gun for a shooting coyotes at close range. However a little bit too loud for my backyard. I doubt of any Moderator would make it backyard friendly.