What's your thoughts on AEA airguns? Are they hype or legit?

Jump to latest Follow Reply
oldmojo said:
Just 1 or a total of .100 inch, any more than that and you might not even get the cap back on, my 30 with 32 already has a firm spring so it was a challenge but im guessing yours is going to be like the other standard challlengers and a bit more manageable.
Click to expand...
So the spacer you are installing goes in between #63 & #64. Is that correct?

Screenshot_20250817_123302_Drive.jpg
 
Upvote 0
Amadorshooter said:
Alright, well I guess I'm going to machine one this week hopefully. I was going to make it out of stainless, unless you have other material suggestions
Click to expand...
I actually make these stainless john deere parts at work on a Swiss lathe, the ID and OD are perfect so I just took a few thousands off the length and made a few extra
 
Upvote 0
oldmojo said:
Im curious what this does on a chronograph, I don't have one. I do think just a firmer spring with the same dimensions would be a little better but I can't find one.
Click to expand...
Well if you have a extra spacer I can let you know! Haha
I will post my findings after I install the spacer. Just have to pick through my materials and see what I have, hoping I can make one from some solid rod I have. Just need to check the diameters it needs too be vs what I have on hand.
 
Upvote 0
Amadorshooter said:
Well if you have a extra spacer I can let you know! Haha
I will post my findings after I install the spacer. Just have to pick through my materials and see what I have, hoping I can make one from some solid rod I have. Just need to check the diameters it needs too be vs what I have on hand.
Click to expand...
I can mail you one if you want to wait that long
 
Upvote 0
Also I thought I seen you were going to get a huma regulator? I'd look into proper degassing or maybe i got the weep hole dirty i dunno, but I tried one and overnight lost some pressure so I was going to take it apart and see what was going on and started degassing by loosening the air gage and the plenum must have had pressure in it and when the take got below that level it shot the regulator up in the tank and there is a o ring on the bottom that makes the seal against the valve housing and it came off then the regulator dropped back down wedging itself on the o ring and I had to hammer it out with a wood dowel so then I decided im done forever with regulators
 
Upvote 0
If you want to throw in a few bucks I could send a ammo test sample , I have a variety of pellets and zan 51 & 60 grain slugs but it'll take more than a stamp to send that, the spacer i can probably just send with a stamp and willing to do free and if it works for you and your happy you can always tip me on PayPal but not needed, im eager to see what the chronograph says, one of these days I'll buy one but I definitely notice more consistency
 
Upvote 0
oldmojo said:
If you want to throw in a few bucks I could send a ammo test sample , I have a variety of pellets and zan 51 & 60 grain slugs but it'll take more than a stamp to send that, the spacer i can probably just send with a stamp and willing to do free and if it works for you and your happy you can always tip me on PayPal but not needed, im eager to see what the chronograph says, one of these days I'll buy one but I definitely notice more consistency
Click to expand...
I would be more than willing to do that!
 
Upvote 0
You must log in or register to reply here.
Top Bottom
Back
Home
Forums
Resources
Menu