Tuning Vulcan 3 fill issue

[JeffG]

So I found the problem; there is a flathead countersunk screw and o-ring inside the fill block at the end of the air tube. The screw and o-ring are behind the tiny hole inside the fill port. The screw was loose and was cock-eyed. I tightened it down, reassembled everything, and now the air stays in the rifle after bleeding off.

View attachment 194109

Just saw this reply. I’ll have to try that and see if it works. I have to find that screw you are talking about.

 

[JeffG]

Just saw this reply. I’ll have to try that and see if it works. I have to find that screw you are talking about.

Got it resolved! Same way you suggested in this thread. All is good now and the gun is filling normal again. Thanks!!