I just got a reximex throne gen 2. My first pcp. I shot about 25 times and then the cocking handle wont stay in the home position. Any advice would be greatly appreciated.
Other Reximex throne gen 2 Broke
- Thread starter schleprock
- Start date
Are all the pins/screws that operate the cocking leaver in place? And is there anything preventing the pellet probe being seated?
Upvote 0
Is it possible you double loaded?
The black slider on your gun right above the cocking handle is not traveling to the full forward position.
Pellet probe not seating fully or possibly the shaft bent.
Two hex nuts (2mm I think) cover the shaft going back to the probe and magazine.
If double loaded you may have to take a long wooden dowel and tap the pellets out.
Upvote 0
That’s because your cocking handle is crazy bent!!! So now it’s operator error. You left that little detail out of your question. It doesn’t just happen on its own.
Last edited:
Upvote 0
yes. problem is exactly this. must’ve forced a jam pellet into the breech.
BTW thanks for that awesome .177 akela i ordered from you guys! i didn’t think i’d enjoy shooting .177 as much as i do. it shoots so nice, it earned an element scope.
Upvote 0
Dont know where you would get the part.
Unless somehow it is covered by warranty you might as well try to straighten the arm.
Unless somehow it is covered by warranty you might as well try to straighten the arm.
Upvote 0
Looking into getting it out. I'll let you all know how it turns out. Thanks very much for your knowledge and time.
Upvote 0
If the lever is as bent as I think it is, straightening will probably shear it off at the bend. If you've never removed a jammed or double loaded pellet there are plenty of past posts here on best methods to try. Usually pretty easy unless pieces broke off & got inside the works. (Rubber mallet & dowel rod might be required).
Upvote 0
Back in action, fellas! I took it out and straightened it. It was harder than I thought it would be. I thought I would be able to bend it like putty. Not the case. I had to put some effort into it. Again, Thank you all very much. I'll sleep tonight.
Upvote 0
Upvote 0
Upvote 0
Do like the gun. I got mine in a bid I didn't think I'd get it but .what do you think of thus gun
Upvote 0
Good thing about that gun is pyramid air has parts. Even if you straightened it I’d still order an extra to have on hand(while u can). Just incase part has a weak spot now.
This is just the lever for $7. Your can get linkage, screws, bushing, etc separate. Theres a a parts diagram.
Rob
This is just the lever for $7. Your can get linkage, screws, bushing, etc separate. Theres a a parts diagram.
Reximex Throne Cocking Lever | Pyramyd AIR
We've got a great price on Reximex Throne Cocking Lever at Pyramyd AIR. Shop where the experts do!
www.pyramydair.com
Rob
Upvote 0
advice,never force it,you bent the cocking lever ,that should be hard to do.Think before you react.
Upvote 0