I'm looking to buy a Yokozuna for my .25 FX Maverick and .22 Panthera Hunter Compact. Should I size up a caliber and get the Yokozuna in .30? Or should I get the Yokozuna in .25?
DFL Moderator Caliber Sizing
- Thread starter zerochance
- Start date
They are already up sized for you, but I highly suggest looking into a STO Falx, they actually work, are light and cheaper than a Donny.
Upvote 0
I have stated this before, but I will repeat this fact again. Most commercial moderators have bores much larger than optimum for good noise attenuation. You do not have to take my word on this, just measure them up yourself. I have found that optimum clearance between the exit diameter of the munition and the moderator bore should be about .020" or .5 mm. Anything tighter than that does not make an appreciable difference. I suspect the reason that commercial moderator bores are much larger is clipping. In order to not cause clipping requires that the moderator must mount square and exactly inline to the barrel bore and it is unfortunate that many will not because the moderator mounts to shrouds which may not be perfectly inline to the barrel. In which case clipping occurs along with customer complaints. This condition is easy to detect with an alignment rod which exactly matches the exit diameter of the barrel. Once placed into the barrel through the mounted moderator the rod should be exactly centered in the exit diameter of the moderator. This is a simple and fast test which should be done every time a mod is mounter to the gun. It takes very little to skew the mount out of alignment. More unfortunately, no one sells these test rods, you have to make your own.
Upvote 0
had the Yoko on my .25 screw on it was a .30 and clipped sold it. I/A 1350 caliber correct almost 1/2 the weight.
Upvote 0
The proper hole for your caliber will yield the best results. So the question is, how much faith do you have in the quality machining on your airgun. A gun that’s machined dead nuts, you can shoot a .22 pellet through a .24 hole no problem. My .22 Impact is shooting through a .235 hole and my .25 Impact is shooting through a .268 hole. High powered sluggers and only 4” mods. Silent. Good machining.
Upvote 0
I had mines clipped too with a .22 using a .25 but had it on a QD. I was thinking it was the QD not seating properly.
Upvote 0
The STO Falx does share some of these features, but it differs from the DonnyFL Yokozuna in key ways:
- Compatibility: The Falx is designed for a wide range of PCP air rifles, but it is semi-modular, meaning it doesn’t have fully adjustable sections like the Yokozuna.
- Threading Options: It comes with standard threading, but it may require adapters for certain rifles.
- Quick Disconnect (QD): Unlike the Yokozuna, the Falx does not have a QD system, meaning it must be threaded on and off manually.
- Modular Sections: The Falx is serviceable, but it does not allow for stackable sections to adjust length and weight like the Yokozuna.
- Materials: It features an anodized aluminum tube, making it lightweight and durable, but it does not use 7075 aluminum for the housing.
- Caliber-Specific Options: The Falx is available for multiple calibers, but it does not have the same modular tuning flexibility as the Yokozuna.
Upvote 0
Doesn’t weigh 12 lbs, with janky QD.
Thanks for the DFL infomercial, the Huma mod 40 or 50 would be my pick for modular piece setup. Don’t worry I have already gave my money to DFL a few times lol
Upvote 0