Here is a pic of the good + bad reservoir pipe i had.
If you want to run large plenum then you take the regulator out and flip it 180 degrees so the " adjustment " screw fase the other way, as i recall the spacer cylinder still go where it is, or do you alsoswap the cylinder spacer, i can not remember, the main thing is to have the REG so it can breath thru the same hole.
Then you swap the 2 ends around and then the whole cylinder around so the adjudgement screw on the REG are still facing the high pressure side / towards the bottle.
For the hell of it i have actually tried to run the big plenum way even in my rifle is the .177 one, it did not have any say at least in regard to accuracy.
In the the other end of the plenum pipe you just have the one safety bleed hole that sit over the thread of the end caps.
If you want to run large plenum then you take the regulator out and flip it 180 degrees so the " adjustment " screw fase the other way, as i recall the spacer cylinder still go where it is, or do you alsoswap the cylinder spacer, i can not remember, the main thing is to have the REG so it can breath thru the same hole.
Then you swap the 2 ends around and then the whole cylinder around so the adjudgement screw on the REG are still facing the high pressure side / towards the bottle.
For the hell of it i have actually tried to run the big plenum way even in my rifle is the .177 one, it did not have any say at least in regard to accuracy.
In the the other end of the plenum pipe you just have the one safety bleed hole that sit over the thread of the end caps.
Upvote 0