Programming question Helliboard
- Thread starter Csbrown5
- Start date
I was not sure so I did voltage change to get close to 863 fps and then did my testing on r values and then made my changes I got this 21 Spread to 14
Upvote 0
A voltage change raises or lowers the whole curve. A dwell change will only affect the pressure point you're changing it at. There are 20 pressure points... the voltage applies to them all. Each will have an associated dwell that only affects that pressure point.
Bob
Bob
Upvote 0
Pulsar owner here.
I have not changed the voltage.
Right after getting my gun, and trying to learn the Heliboard, I accidently changed it, but put it back to where it was when I bought the gun,,,used.
No problems at all, in changing the pellet speeds using just...the pressure.
Mike
I have not changed the voltage.
Right after getting my gun, and trying to learn the Heliboard, I accidently changed it, but put it back to where it was when I bought the gun,,,used.
No problems at all, in changing the pellet speeds using just...the pressure.
Mike
Upvote 0