Any one have a picture of the breach seal installed on the Diana 54 ? looks like installed with the breach open ? All i can find on the internet is a Schematic .
breach seal / Diana 54
- Thread starter beerthief
- Start date
Same as a 48. Grind the point off a lag bolt. carefully thread it into the old seal a turn or 2 and pull it out. I cock the gun, then close and open the breech just to the first click of the anti beartrap, so the piston seal isnt up against it. New seal just gets pressed in place, it will get bottoned out when you close the breech.
Upvote 0
If it is the original breech seal it will be stuck more than you expect. Don't pull until you think you have good thread engagement.
Upvote 0
i do not see any seal in there , bought it used so i will put new seal in . seems to work just fine but low FPS 630
Upvote 0