Threads

ToddGeddes63 · Feb 28, 2024

DOT/date certified tank if you are having a shop fill it.
If you are filling the tank, then a CE tank is fine.
I would think that the DOT certification is needed when transporting a tank, such as flying, train, bus?
Maybe someone that travels with a tank would confirm?

jd72ke9z · Feb 23, 2024

Looking to buy a higher end pcp for tuning to higher power.

3Crows · Feb 23, 2024

Europe is not America and the realities of the two markets are vastly different. Especially west of the Mississippi. Fly over country, 12 fpe, is that a joke!

There is no rifle that is silent enough to support shooting air rifles where air rifles are illegal. Even at an anemic 12 fpe. The reality here is to move to outside the city limits or away from whatever is restricting your shooting activities. Which in North America is much easier to do than in Europe. Noise is not the only issue, bad things happen and a pellet can stray off to some place it does not belong, even at 12 fpe. If the complaining neighbor is upset by a little noise, imagine what a pellet will do to their karma if it is found stuck in the bumper of their Telsa.

klentz · Feb 26, 2024

Here is an 11 part series that was done on the Air Arms S510 (regulated) Ultimate Sporter in .22 caliber. The link is to part 11. Scroll down a little and click on Part 1-Part 10 in order to read them in proper sequence:

Air Arms S510XS Ultimate Sporter with Laminate Stock: Part 11 | Pyramyd AIR Blog

I have been wanting to write this one and today I have two things to do with my Air Arms S510XS Ultimate Sporter with Laminate Stock precharged pneuatic (PCP) rifle. I'll test a new pellet for this rifle today and I'll also test a theory that many of you believe to be true

www.pyramydair.com

Bimhiq · Feb 26, 2024

Does anyone have a picture of FX hammer with peek insert?

Maizen · Feb 22, 2024

Is anyone planning to go compact?

ThE PuNiShEr · Feb 25, 2024

Zeringue said:
Моят Maverick започна като 25 cal 700 mm. Когато го получих за първи път, се гмурнах с главата напред в охлювите. Купих винаги вид и започнах да снимам, дори получих тежка подложка. Никога не можах да накарам това нещо да работи (линия 1:18). Продаден се върна към оригиналния превъзходен. И винаги завършвах на NSA 38.5. Но винаги delt с изместване на poi. Задържани постоянни групи просто лоши POI. Така че най-накрая казах по дяволите с тези охлюви и се върнах към пелетите. Само това върви с Maverick, който смених с 600 mm 30 cal и имам въглеродна вложка. Ще се опитам да публикувам група през следващите дни с hades и 44 jsb. О, между другото, имам почти всеки аксесоар, който Sabre Tactical прави хаха. TRS релса. Cheek Riser. Разширение Arca / Pic. Адаптер за двойна бутилка. И Butt Pad. За капак на надеждния Дони Сумо или Шогун. Харесва ми начина, по който шогунът изглежда на пистолета. Взех и Huma pellet power kit. Но открих, че сондата стърчи прекалено дълга коса и трие магнето. Може би някой може да даде съвет за това. Поставих OEM сондата в пистолета.

View attachment 438388

View attachment 438389

View attachment 438390

Здравей колега.Аз също съм с Маверик 22 и 30 калибър със 700 мм хеви лайнер. Нямам проблем с точка на попадение, нямам сабер тактикал арка. Иглата която вкарва слъговете на хума е по-дълга, трябва да я отрежеш малко. Постяви я отново в пушката, дръпни лоста за зареждане докато заключи, погледни вертикално отгоре и виж тази част която се подава от отвора на цевната кутия, маркирай с нож или фин маркер. След това освободи напрежението на пружината към ударника със сух спусък ( държиш сайдлевъра докато натискаш спусъка за да не се възпроизведе изстрел ). Вадиш иглата за слъгове, и я скъсяваш внимателно с подходяща машина ( шлайф, шмергел ) , накрая и придаваш леко заоблен връх.

Screenshot_20240225_073809_com.android.gallery3d.jpg

uladz · Aug 2, 2025

This listing has been renewed

Aslap · Wednesday at 1:36 PM

I did exactly that. Avenge X 25 cal. I was shooting 25 grain pellets at 920 and would get around 50 shots on a full fill. I got some 20 grain pellets and used the low transfer port setting with those. Here is the thread. No tune change.

Air Venturi - Interesting Avenge X shot string

Avenge X tube version. HN Field Target Trophy pellets at 20 gr. Reg set (I think) at 150B. Transfer port set to LO. Started at full fill of 300B and ended the shot string at 120B. I have always questioned the regulator in this gun. I only plink at 25 yards in the backyard so no reputation or...

www.airgunnation.com

It worked pretty darn good!

Tony

albertogta · May 2, 2024

This listing has been renewed

Rawroots · Feb 29, 2024

Emu · Feb 22, 2024

Ranchibi said:
Sounds like a great hunt Emu with your AGT!

Short, but useful for the training of my two retrievers.

The more experience the best they become.

wlfpck · Dec 27, 2024

Does anyone sell the plenum pre-ported? I don't really have the tools to accurately do this myself.

I'm assuming porting this would not really cause issues with say shot count dropping or anything right? Or does the existing port act as a restrictor plate to keep too much air from being used?

PCP Airfunner · Mar 2, 2024

This listing has been renewed

PCP Airfunner · Mar 2, 2024

This listing has been renewed

Hicap97470 · Feb 25, 2024

Gerry52 said:
What OTHER pellets have you tried? There might be others that are even more accurate. JSB 18.13GR are the "gold standard" for MANY of us .22 owners.

Yeah gona give those a try also thanks

F6Hawk · Feb 24, 2024

Took me 30 minutes to take my GW 97cu ft from 230 to 245 bar tonight. 4 minutes of that were just filling the filter.

Temps -
Ambient - 72.2° F
Coolant - 75.0° F
Head - 74.9° F

Final -
A - 68.4°
C -112.2° F
H - 114.3° F

cavedweller · Feb 23, 2024

manabeknives said:
@cavedweller -they are called Tyrolean stocks

thanks.... now i'm remembering whiscombe is a type of springer $$$

r2daizzzo · Feb 24, 2024

I'm like modding so I added a power plenums and a bottle adapter for a 500cc bottle. Currently look for a custom stock

rangur1 · Feb 22, 2024

Have 7 tins 350 ct each. 4 JSB and 3 FX. These tins are not sealed. All pellets were sized by pellet gage. The JSB are 6.38, FX are 6.37. All scale weighed at 25.3 - 25.39g . All have been lubed with strike hold. $15 per tin. Will split in 2 groups, JSB or FX . Or you take them all for $95 PayPal F&F , conus. Thank you.

LM22 · Feb 29, 2024

I think that's about as good as it is getting

bustachip · Feb 23, 2024

Mycapt65 said:
The 50 has a 100 yards parallax 4x on it too. I love this package. Light,handy and no fiddling with adjustments. It's the middle gun.
View attachment 438514
Truth is the 97 typically shoots better than those first four groups. It later shot almost the same sizes at 50 yards as I first did with it at 25. All that and you still couldn't pay me to carry the 97 around the property. The 50 is my squirrel gun. Always shoot minute of squirrel. It's one of my most consistent POI springers.

50 looks like the perfect squirrel gun.

rangur1 · Feb 22, 2024

Have 6 tins combined of the following:
2 of polymags total 620 ct.
2 of FX Atomics total 1000 ct
2 of FX 15.9 domes total 1000 ct
These are not sealed tins, all pellets are great condition, no bent skirts, no missing polymer tips. All lubed with strike hold.
$ 90 shipped, conus, PayPal F&F , thank you.

rangur1 · Feb 22, 2024

Have 3 tins 350ct JSB 25 cal pellets. They have been sized with pellet gage at 6.38 and weighed to a 1/10 of a grain. Lubed with strike hold. Weight reads 25.5 - 25.59g . $45 shipped conus, PayPal F&F , time stamp dictates as usual. Thanks.

aylesboy · Mar 13, 2024

Hi I've got a 2020 .22 red wolf and i'm interested in purchasing a Heliboard for it My email is [email protected], anyone able to help get a request to the seller

Thanks in advance Mike

Threads

Threads

Filter