Air Arms Utah Airguns Pyramyd AIR FX Airguns Daystate Diana Airgun Depot Edgun West DonnyFL: PCP Air Rifle Shop and Airgun Moderators The Pellet Shop Airforce Airguns
Saber Tactical Optisan Side-Shot Scope Cam NE Airguns Baker Airguns AGS Topgun Airguns Predator International Huben Airguns Huma-Air Shooting Supplies Hurricane Luftvapen AEA Precision Airguns H&N Impulse Air ZAN Projectiles Hawke Optics Stud Mag Loader RX Target Systems Sports Match Scope Mounts Altaros Banner CTA Thomas Air Hatsan USA Georgia Air Guns Skout Airguns Nielsen Specialty Ammo Patch Worm Weihrauch Sport Talon Tunes Airgun-Revisions JTS ST7 PPP RTI AirStryk Industries Macavity Arms Vector Optics Corbin

  • Question
Question about Mrod with the LW barrel

Hellow everyone, I am new to this site and pcp air guns. I purchased a Benjamin marauder F&T with a Lothar Walther barrel. I have a sparrow infestation and my 35 year old Benjamin pump is wore out. I am wondering
Is there a designation on the rifle itself the shows it is equipped with the Lothar Walther barrel? The model number on the box shows BP2264RLW But the model # on the rifle just shows BP2264R. Thanks

  • Question
Wolverine losing power

I have a 2 year old Wolverine R in .177. It was shooting the JSB redesign 13.43 at 810 to 815 FPS. Now I am down to 770 FPS. The breach seal seems good, I feel no air escaping there, and the spread between shots is < 10 FPS. The regulator is still at the factory setting of 145.

Any ideas on what is going on? Does the hammer spring/throw need adjusted? Could the regulator need serviced?

Thanks

  • Question
AEA HP carbine power knob wandering from recoil

Hi, just got an AEA hp carbine and the power knobs wanders. After about a mag and a half it will migrate from 12 o’clock to about 8 o’clock . At which point the action won’t cycle. I’ll turn it back to 12 and it works again. Anyone else have this issue?
Also there is no way to tighten it, I notice the older ones have a slot screw on opposite side. This new one doesn’t.

74AA4C6A-1E0E-4333-9A8D-6ED71BC656D1.jpeg


B2E4F855-9E4E-424B-841B-A2C4A3CDD1C3.jpeg

  • Question
AEA hp carbine bolt won’t close

Hi guys just got this gun it has less than 50 rds through it. It “jammed” about halfway through a mag, I was able to remove to mag easily but now the bolt won’t go fully forward. There are no pellets in the barrel, I ran a dowel down it , so it’s clear. I pushed the bolt forward pretty hard but it won’t seat. I guess I’ll contact the seller on Monday . Any ideas? Thanks

image.jpg
  • Like
Reactions: RAMJET66

Filter