This listing has been renewed

CA is hard to save, in the best case it will take more than a decade!

I appreciate and know you were only trying to help. I am not frustrated at you, but at the manufacturer. I should have added, and there...

Pard was kind enough to send me a few at no charge.

I think you are right. I just viewed the ‘how to refill a 300 DIN tank’ Coltri YT video. The tank and compressor were at the same...

Caliber? In .25 the fx 34gr pellets perform excellently here, as does the JTS Dead Center Precision 33.80 grain. In .22 the FX...

Hi! I am on the brink to order a RTI Mora sniper, but i see some issues are discussed here and there. What are the main issues of the...

I know this is the PP700 but it's the exact same as the NOTOS just the opposite side. Pay attention to the small bits and where they go...

I have one, extremely accurate out to 35 yards, that’s as far as I shoot. I have the 20 fpe, .20 cal, carbon fiber tank model. I don’t...

Here's one reference. This makes it seem like it's only IR scopes though...

Where did you read this? My read is that night hunting of pests (defined in the Code) is OK on property where one has permission to...

I’m not suprised he copied Orions mags He’s a thief. Same way china built it military, stolen tech.

Here’s my story. I was pumped after I bought my RTI Prophet 3 .30, so I jump on bay and find QD Fox mags has a P3 12 round mag, shows a...

Where did you read this, about the night vision? For pest control, or animals "depredating one's crops", I don't see mention of...

I was about to convince Joe Polanco to join. 😆 Anyway, thanks for the info.

The pellet probe has a lot of slop in it, Not sure how to tighten it up, Take the magazine out and fill the probe it slides back and...

Or @SekhmetAirgunAcc .. maybe they will come here

Yes for sure I will be in the line for my HW97.

I tried several magazine, oem and 3d printed same issue, so its probably a barrel misaligned or something, ill check this weekend and...

I have already removed the barrel and re tighten it several times, i will have to remove the second air tank to se if that is the issue...

Sorry. Hope it gets worked out. Hate to make another suggestion but I will anyway. Try messaging them here

another possibility is that the magazine screw is too tight and just needs loosen a little bit. Mark