I recently bought an X barrel upgrade for my Gen. 1 FX Impact. The plan is to get the slug liner for it but now I realize that my Gen.1 might not be able to generate the energy needed for slugs owing to the fact that you aren't supposed to go above 142 bar ( according to my manual) on the regulator.
I know that the FX Impact X, (Gen. 2), has a bigger beefier regulator that can go much higher. I think I read where Matt Dubber plans to run his Gen. 2 up into the 170's for his slug shooting.
So do us Gen 1-ers bite the pellet on this one?
Speaking of Gen. 1 regs., Matt wrote on this forum that FX had gotten some bad bellville washers from their supplier in the earlier Gen. 1 days and as a result people had creeping regulators. They rectified the situation..... I'm wondering when that occurred as I have had some reg creep. If heavier washers would allow me to up the pressure beyond 150 then that might do the trick.
Thanks,
KP
I know that the FX Impact X, (Gen. 2), has a bigger beefier regulator that can go much higher. I think I read where Matt Dubber plans to run his Gen. 2 up into the 170's for his slug shooting.
So do us Gen 1-ers bite the pellet on this one?
Speaking of Gen. 1 regs., Matt wrote on this forum that FX had gotten some bad bellville washers from their supplier in the earlier Gen. 1 days and as a result people had creeping regulators. They rectified the situation..... I'm wondering when that occurred as I have had some reg creep. If heavier washers would allow me to up the pressure beyond 150 then that might do the trick.
Thanks,
KP