WTH! Benjamin Marauder Loaded all 10 Pellets from the Magazine into the Barrel!

Trigger blade can be broken internally. I would push out all pellets if possible and very carefully. Or remove the breech from the gun to keep it safer. Just make sure the gun is pointed in a safe direction. Then pull the cover off the trigger housing and see what's up.

I had a similar problem but found out I was not pulling the bolt back far enough. It will stop a certain point and then you have to manhandle it back more to get it to cock. That part has gotten easier as the gun has broken in with use.

My son did that with my .22 Marauder but he only got 4 pellets into the barrel and on mine what happened was he didn’t pull the bolt all the way back, you know that last 1/8 - 1/4 of a inch that can be hard to do, so he just pulled the bolt back again letting the mag cycle to the next round and push in another pellet, it took me a bit but after tearing it down some I ended up getting the four pellets out using my 22 cleaning rod and tapping it to knock out the pellets, it wasn’t easy but eventually I got them all out, I loaded a pellet the correct way and it shot just fine, needless to say he did the same thing two more times but with only 3 pellets, the last time I thought the barrel was going to be shot, the pellets were wedged pretty good but again I got them out and it still works ok, the rife is now a leaner next to my safe.

Needless to say he no longer shoots the Marauder,I let him shoot one of my other airguns with a side lever, some people just can’t get the hand of pulling the bolt all the way back, he had a hard time with my BT65SB also so he no longer shoots that one, he really likes my .25 Wildcat hahaha.

Good, glad ya got it cleaned out and working. That’s how I found out that the sidelever is the best for beginners and by no means put them on the bench with the BT65SB that’s 3 times harder then a Marauder.

He forced it so much your trigger pack was canted & sear cocked at an angle. That's my bet. Was there really 10 pellets in there? This is why no one except my Dad is using my air guns.

Daughter did that with my Woodwalker. Tapped pellets out with .17 cleaning rod also. Had trigger problems with the same Woodwalker b4 that. A spring had come undone inside the trigger group. Easy fix for me and I know nothing about working on them. YouTube helped greatly!

I've seen a similiar issue with my Benjamin Armada. Never loaded all 10 pellets but definitely have fired two pellets out at the same time (surprisingly accurate too). Took me a while to figure out why and how two holes had just appeared in my target. Never loaded all 10 though...