Will 1/8bsp gauge fit in the impact?

PigeonMan · Sep 23, 2019

Not sure what threads are on the impact. Just wanna know if gauges with 1/8 bsp will fit without any mods.

Will wika gauge fit for the regulator gauge? I asked huma which sells them and this is what they email me back.

The regulator gauge is 23 mm so much smaller. We would not advice to use wika gauge in it as it only has a few turns of treads

All the best

Team Huma-Air

Spray1Mark · Sep 23, 2019

How bizarre, just put an o-ring underneath, plenty use them.

Tominco · Sep 23, 2019

Should be 1/8 BSPP on the Impacts. I can confirm that the 1st generation was 1/8 BSPP for sure.

Glem.Chally · Sep 23, 2019

Ive had both the Wika 25mm and the EDMU where the reg gauge goes. No issues.

PigeonMan · Sep 23, 2019

Ok thanks. Will buy two, one for bottle gauge and one for pressure gauge.

PigeonMan · Sep 23, 2019

Ive had both the Wika 25mm and the EDMU where the reg gauge goes. No issues.

On huma site they list wika gauge as 28mm. Not 25mm.

Glem.Chally · Sep 23, 2019

Ok thanks. Will buy two, one for bottle gauge and one for pressure gauge.

If you get a couple #105 sized orings you can put them below the gauge and that will make it easy to orient the gauge and get a good seal. Many degrees of sealing, hand tight is good the pressure makes the seal.

Yeah you might be right, might be 28mm. Whatever the EDMU is its that size.

Search

Search

Will 1/8bsp gauge fit in the impact?

PigeonMan

Member

Spray1Mark

Member

Tominco

Member

Glem.Chally

Member

PigeonMan

Member

PigeonMan

Member

Glem.Chally

Member