Wildcat trigger help [FIXED] Thank you all!

Jump to latest Follow Reply
Redick

Redick

Member
Nov 9, 2019
1,546
26
Ohio, United States
I'm fixing some problems with the wildcat and after replacing some orings and putting it back together. I noticed the trigger is really stiff and stays to the rear position when pulled and does not reset. If I pull the trigger it still will not reset but it will fire but feels like it's going to break. Any help is greatly appreciated added a few photos in case if anyone notices any wrong

1585190802_17857802545e7c17921c7e20.33815993.jpg
1585190826_9889812025e7c17aa41ec62.09995833.jpg


1585190866_5645665995e7c17d29b9f96.49704853.jpg
1585190902_3679342605e7c17f6f25aa0.09742258.jpg

 
This will help. For trigger adjustments.







https://m.youtube.com/watch?v=CoXRtXwQV9Q





But if you had the tube out of the gun or loosened the clamps, you have an alignment issue.

Click to expand...

I think you are right about the alignment because I did happen to twist somehow because the tube was off when I went to tighten it back up. I'll disassemble tomorrow and start over


 
Upvote 0
Almost 100% an alignment issue. Hopefully you took measurements before disassemby, but if not, you might try looking VERY closely at the tube from minor marks left from the clamps. There is also a video (YouTube) of this issue shown minorly on an AoA vid.

Plus this from about a week and a half ago....

https://www.airgunnation.com/topic/so-this-happen-today-how-can-i-fix/

mike
 
Upvote 0
Almost 100% an alignment issue. Hopefully you took measurements before disassemby, but if not, you might try looking VERY closely at the tube from minor marks left from the clamps. There is also a video (YouTube) of this issue shown minorly on an AoA vid.

Plus this from about a week and a half ago....

https://www.airgunnation.com/topic/so-this-happen-today-how-can-i-fix/

mike
Click to expand...

I did not take any measurements. I went off Aoa's video on replacing orings and fudged it up along the way. Thanks for the help
 
Upvote 0
Almost 100% an alignment issue. Hopefully you took measurements before disassemby, but if not, you might try looking VERY closely at the tube from minor marks left from the clamps. There is also a video (YouTube) of this pnissue shown minorly on an AoA vid.

Plus this from about a week and a half ago....

https://www.airgunnation.com/topic/so-this-happen-today-how-can-i-fix/

mike
Click to expand...

I did not take any measurements. I went off Aoa's video on replacing orings and fudged it up along the way. Thanks for the help
 
Upvote 0
You must log in or register to reply here.
Top Bottom
Back
Home
Forums
Resources
Menu