thread sealer??

Forums General Discussion thread sealer??

  • Views : 294
  • Link

    karterguy
    Participant
    Member

    doing some home tuning and have some grub screws that seal holes where ports were drilled what kind of sealer should i put back on the grub screws?? 

    Link

    marflow
    Participant
    Member

    are they in an under pressure area or a pressure transfer area

    Link

    karterguy
    Participant
    Member

    marflow

    are they in an under pressure area or a pressure transfer area

    yes they are

    Link

    R_M_F
    Participant
    Member

    I believe locktite 545 is good for 10000 psi. 

    Link

    mark2cars
    Participant
    Member

    +1 to R_M_F….used it B4

    Link

    karterguy
    Participant
    Member

    is that a lock tight that's removal tho?

    Link

    Bigragu
    Participant
    Member

    Try some of this:

     

     

    Ive used this Nylog on the threads of a Marauder pressure gage, no leaks. I’ve made up two sets of 90 degree quick disconnect fittings that had all NPT threads, no leaks. Only need a tiny bit spread out to all the threads.

    taking fasteners apart later on, no sweat. It will not harden over time, and applies clear and stays clear

    • This reply was modified 5 months ago by Bigragu.
Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.