DAYSTATE REPORT

It probably should go back to a Daystate service center. Sounds like it is the O ring attached to the solenoid or the solenoid itself. Either way you will need parts and a whole lot of Know How. Don't think this one is a DIY project, Sorry

Hello 

The leak you described is almost always the valve seal. 



Rob. 

Couldn’t resist! 

I’ve had over a yr. it was just a nice sunny day above average temperature so I did some plinking! 25.4’s on Hp 18.1’s On Lp will also shoot NSA 20.2’s on Hp as well! only tested @ 65yds but very encouraging!

I put my Red Wolf on a diet. I replaced the SWFA 3-15X42 FFP 30mm tube scope with a 1" tube Bushnell Elite 3200 7-21X40 Mil-Dot. I probably lost 1/2lb , probably more with the sunshade and caps, with the exchange. The SWFA is a fantastic scope but was more than I needed. 

SWFA

[/url][/img]



Bushnell

[/url][/img]

That stock is a beauty, sometimes I regret not ordering mine in walnut? something about walnut and carbon fiber that speaks to me... I really like the safari stock as well 

I put my Red Wolf on a diet. I replaced the SWFA 3-15X42 FFP 30mm tube scope with a 1" tube Bushnell Elite 3200 7-21X40 Mil-Dot. I probably lost 1/2lb , probably more with the sunshade and caps, with the exchange. The SWFA is a fantastic scope but was more than I needed. 

SWFA

[/url][/img]



Bushnell

[/url][/img]

Click to expand...

Yeah great looking!

Something showed up in the mail today. .177 18fpe

I have both RW and BM-500 two different disciplines though!

walnut and that carbon shroud... just wows me.. thanks for posting.. red worlf and the iar wolf are very fine guns...…. im not sure weather id want a red wolf over my raw 500 bm! 

any one else who owns a raw but also wants a red wolf or owns one!

My First PCP Rifle was the RAW BM500, it was used and purchased off the forum. Only wish it had the side lever instead of a bolt. Also I then purchased the Wolverine SG from the forum, and instantly fell in love with the rifle, so much that I will be getting my New Wolverine HP tomorrow from AOA. They made me a nice package deal. I'm not 100% sure I want to get a Red Wolf, I have a itch to buy the new HM1000x LRT in .25 cal. Its one sweet looking rifle.

Click to expand...

.177cal and .22cal HP

22 HP with Heliboard installed today.

22 HP with Heliboard installed today 

.22 HP shooting slugs @ 340 yards!

Went out today with the .22HP to get it sighted in at 30 yards and try it a little further. The weather was crappy and cool (10C or 50F) and windy. Shot this group at 50 yards with the 25gr redesigned pellets. The black squares are about 9/16ths of an inch each.



I put this spinner target out at 66 yards and Strelok Pro gave me the elevation amount. 5 shots.



This rifle definitely put a smile on my face today. I tried some JSB 18gr pellets on Low power, they were zerod at 30 yards as well and I was plinking stones on the pile at 46 yards with the correct elevation from Strelok Pro. As I was packing up I was thinking if I only wanted 1 rifle, this would be it. I'm looking forward to a warm day with no wind and I will try some 100 yard groups.

Hey gang,

I posted this thread in another part of AGN, but I wanted to try here in the Daystate Report thread. Any luck shooting slugs of any brand for .25 RW? I am specifically interested in 100 yard accuracy for bench rest for either pellets or slugs. I have this gun for a couple of months and I am not yet seeing the accuracy I was hoping for at 100 yards for outdoor bench rest. Lots of details in the thread below. Any thoughts/suggestions are welcome of course, AFTER you read this thread. Tx, Tom 

https://www.airgunnation.com/topic/what-are-your-best-pellets-and-slugs-for-25-safari-for-100-yard-bench-rest/

Here is a target string between my RW and my Bantam. My bantam outshot the RW by a lot. What could be the problem?

The top row is the Bantam and the next two rows, the RW and the bottom left is the Bantam at the end of the shot string.