rws 54 question

Forums General Airgunning rws 54 question

  • Views : 179
  • Link

    josh3rd
    Participant
    Member

    Quick question. Upon taking the 54 out of the stock there are 5 big washers from what I remember. 2 are close to the trigger and near the forend are 3. I forget how they go sequence wise. I tried to look at a schematic but it's unclear if their names. So near the for end is it a rubber then metal then rubber or vice versa and lastly where can I find that info? An NO it's not on Eddie's page either so need for a link. Thank you

    Link

    shambozzie
    Participant
    Member

    Josh,  try contacting John in PA for that info and anything in reference to rws 54. Think I will shoot some grey labels  in mine today. How have u been buddy. Tommy.

    Link

    josh3rd
    Participant
    Member

    Awe Tommy whats going on brother? Its cold here in se pa so I'm assuming it's cold down in MD too?

    Link

    VETTNUT
    Participant
    Member

    You might also try Hector at https://www.ctcustomairguns.com/

    Link

    prfleetsvs
    Participant
    Member

    Hi Josh,

    Forward set of three, the rubber washer goes in the middle, sandwitched between the two metal ones.  The rear set, the metal washer faces the action, the rubber washer faces the stock. 

    Pedro in PR

    Link

    josh3rd
    Participant
    Member

    prfleetsvs

    Hi Josh,

    Forward set of three, the rubber washer goes in the middle, sandwitched between the two metal ones.  The rear set, the metal washer faces the action, the rubber washer faces the stock. 

    Pedro in PR

    Thanks Pedro

    Link

    Lewis
    Participant
    Member

    prfleetsvs

    Hi Josh,

    Forward set of three, the rubber washer goes in the middle, sandwitched between the two metal ones.  The rear set, the metal washer faces the action, the rubber washer faces the stock. 

    Pedro in PR

    Pedro is spot on.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.