Hi!
2 days ago i was targeting and my regulator was set on 140 bar as usual and when i finished i took off the bottle. The second day when i installed the bottle the regulator jumped from 140 bar to 200 bar at the same lvl the bottlewas filled, so i changed all o rings and settled it back again to 140 bar.
The problem is today: the regulator was still on 140 bar but when i installed the bottle which was filled 175 bar, the regulator jumped to the same level 175 bar. When i vaccum it by shooting out the air, it took more than 10 shoots to empty it. When i reinstall the bottle, there's air synchronization between the regulator and the bottle. And if i close the regulator and install the bottle then put it on 140 bar, it stays at this level as long as use the rifle. If i uninstall the bottle the regulator stays at 140, when i reinstall it the synchronization issue occurs again. Can someone enlight me on this issue? Thanks in advance
2 days ago i was targeting and my regulator was set on 140 bar as usual and when i finished i took off the bottle. The second day when i installed the bottle the regulator jumped from 140 bar to 200 bar at the same lvl the bottlewas filled, so i changed all o rings and settled it back again to 140 bar.
The problem is today: the regulator was still on 140 bar but when i installed the bottle which was filled 175 bar, the regulator jumped to the same level 175 bar. When i vaccum it by shooting out the air, it took more than 10 shoots to empty it. When i reinstall the bottle, there's air synchronization between the regulator and the bottle. And if i close the regulator and install the bottle then put it on 140 bar, it stays at this level as long as use the rifle. If i uninstall the bottle the regulator stays at 140, when i reinstall it the synchronization issue occurs again. Can someone enlight me on this issue? Thanks in advance