Hi all, is anyone aware of a recoil pad that would fit the contour of the below? It is not needed for recoil but for bolt action cocking of my non-XR Concept Lite which after 50 rounds starts to eat into my shoulder. Thanks in advance!
“Recoil” pad for Brocock Concept Lite?
- Thread starter LMNOP
- Start date
Appreciate it, was thinking the same as well just was hoping perhaps there was a slip on fit solution. Maybe I will make one out of leather. Thanks again!
Upvote 0
I believe that stock tube ( buffer tube , receiver extension) is the same as on ARs So you could swap out that butt stock for any other stock that works with the M4 carbine type platform. You’ll just need to determine if the tube diameter is Mill spec or commercial diameter.
Upvote 0
Years ago I bought a couple of pre-made but pad for my powder burners. You might look on Midway or Brownells. Look under recoil pad.
https://www.midwayusa.com/product/1151354638
https://www.midwayusa.com/product/1151354638
Upvote 0
Here is what I did to help with the cocking of my HR Bantam bolt gun.
I turned the rear part of the scope rail around. The flat area makes an great place to put your thumb while cocking. SOOOO MUCH EASIER! Before arriving at this simple solution I thought about taking a scope ring, cutting of the ring part off and attaching the base to the rear of the receiver - you may want to try something similar.
I turned the rear part of the scope rail around. The flat area makes an great place to put your thumb while cocking. SOOOO MUCH EASIER! Before arriving at this simple solution I thought about taking a scope ring, cutting of the ring part off and attaching the base to the rear of the receiver - you may want to try something similar.
Upvote 0
Thanks! It cocks easy because of the oversized charging handle but it always bites my shoulder after many rounds. My solution was stupid but it easily comes off and on if I need to be tacticool lol. Two beer coozies inside each other inside out. I need an AGD coozie now and not flip it inside out!
I might try cutting it down but was afraid it would unravel
I might try cutting it down but was afraid it would unravel
Upvote 0
